1. Helmet Light User Instructions Rotate Tail cap counter clock wise to open battery compartment IR / IFF lever (only functional light In this mode) Two functional buttons, One functional lever Insert AA Battery Tip end first Primary – White Light Secondary – Red or Blue Light (one or the other, not both available in each light) Mounting the Helmet Bracket Bracket can be mounted in any location along the rim of the helmet for operator comfort and ease of use. Step 1 – loosen Screw until flush with J Bracket. Step 2 –Install bracket on the rim of your helmet at your desired location Step 3 – When J hook bracket and bottom of mount are flush with the rim of your Helmet, Then tighten screw. Battery Compartment and Installation

2. Helmet Light User Instructions White Light – Top Button (left side mounted) IR Light – Lower Light Red or Blue Light– Top Light White Light -- Center Light Light location Right side Mounted Light location Left side Mounted White Light – Bottom Button (right side mounted) Red or Blue Light – Top button (right side mounted) Red Or Blue Light – Lower Light IR Light– Top Light White Light -- Center Light Three modes of operations Primary and Secondary Light Press 1X – low Press 2X -- Medium Press 3X -- High (if light has been on for more than three seconds, next press will extinguish the light) Red or Blue Light – Bottom Button (left side mounted)

3. Helmet Light User Instructions IR Light— Move lever up to engage IR light (all other lights are disabled in this mode) To Engage IR/IFF Left side mountedTo Engage IR/IFF Right side mounted IFF Mode— Move lever down to engage the IFF mode (all other lights are disabled in this mode) IR Light— Move lever down to engage IR light (all other lights are disabled in this mode) IFF Mode— Move lever up to engage IFF Mode (all other lights are disabled in this mode) To Engage the lock out feature Turn the tail cap ¼ turn (light is still water proof) Tab should be aligned centered with Hard Case Logo IFF Light IR Light Constant On One level of brightness IFF Light Need Flash input

4. Helmet Light User Instructions Step 2— slide light upwards to remove light. Rotating your Helmet Light Step 1 — Depress the T-Bar to disengage locking bracket Step 1 — While mounted gently pull light away from helmet Step 2 — Rotate into your desired position Removing your Helmet Light from your Helmet Mounting bracket has 20 lockable positions within the 360 degree rotation! Step 1 — Depress the T-Bar to disengage locking bracket Removing your Helmet Light from your OTV/FLC Step 2 — Slide light rear wards to remove light. Recommended Hand Position To avoid accidental discharge (AD) of colored lights. Finger position should be end to end.