Presentation is loading. Please wait.

Presentation is loading. Please wait.

#30 Ignition/Starter Switch #54 To Radio Fuse 1 Instrument Power Ignition Coil 87 85 86 30 Red wire with bullet Long black wire with bullet. Wire was.

Similar presentations


Presentation on theme: "#30 Ignition/Starter Switch #54 To Radio Fuse 1 Instrument Power Ignition Coil 87 85 86 30 Red wire with bullet Long black wire with bullet. Wire was."— Presentation transcript:

1

2 #30 Ignition/Starter Switch #54 To Radio Fuse 1 Instrument Power Ignition Coil 87 85 86 30 Red wire with bullet Long black wire with bullet. Wire was removed from #50 of the Ignition/Starter switch. Bullet to bullet splice To solenoid on Starter (#50) To, under the thumb nut holding the Combo Instruments bale to the dash. Bosch Relay #50 #15 20 1.Lift ground strap from the battery. 2.Remove Ignition/Starter switch from dash. 3.Discard locking tab washer. 4.Remove large black wire (#50) from Ignition/Starters switch. 5.Connect the relays long black wire into the switchs hole #50. 6.Insert removed wire (#50) into splice from relay. 7.Push the red wire into the switch #30 terminal. 8. *Land brown ground wire under the thumb nut on the Combo. 9.Mount switch and relay to the dash. 10.Connect the battery's ground. Installation Instructions All #30 terminals are the same points electrically. * The Combo instrument is grounded by the bale cutting into the dash. After connecting the brown ground wire take extra care to tighten both thumb nuts to insure a good ground. Sure Start Relay ki Bullet Type – K series

3 For the early style Ignition/Starter Switch. Ignition Starter Switch 54 50 3015 87 85 86 30 20 Wire #50 removed from the Ignition/Starter switch. Wire #30 removed from the Ignition/Starter switch. 1.Lift ground strap from the battery. 2.Remove Ignition/Starter switch from dash. 3.Discard locking tab washer. 4.Remove large black wire (#50) from Ignition/Starters switch. 5.Connect the relays long black wire into the switchs hole #50. 6.Insert removed wire (#50) into splice from relay. 7.Remove the #30 red wire from switch, and insert into splice. 8. *Land brown ground wire under the thumb nut on the Combo. 9.Mount switch and relay to the dash. 10.Connect the battery's ground. Installation Instructions * The Combo instrument is grounded by the bale cutting into the dash. After connecting the brown ground wire take extra care to tighten both thumb nuts to insure a good ground. After a couple of weeks, retighten the small screws in the two splices. From fuse block. To starter Larger red wire. Splices Sure Start Relay kit Screw Type – Bosch Series


Download ppt "#30 Ignition/Starter Switch #54 To Radio Fuse 1 Instrument Power Ignition Coil 87 85 86 30 Red wire with bullet Long black wire with bullet. Wire was."

Similar presentations


Ads by Google