2. The right choice: Windows and Door Frames Exterior Fixtures Hand Rails Electrical Boxes Hurricane Shutters Screen Enclosures

3. Back out old screwNo need to patch hole Simply enlarge hole with Tapper+ Bit Drive a new Tapper+ Xtreme You’re Done!

4. CodeApproval 2012, 2009, 2006 and 2003 IBC & IRC ESR-3068 2010 Florida Building Code- Building & Residential ESR-3068 FBC Supplement Miami-Dade County Notice of Acceptance NOA12-1205.10

5. *Based on Manufacturer Published literature, 1-3/4” embedment

6. When salt spray tested head to head against the ITW Tapcon® with the Climaseal coating the Powers Tapper+ PermaSeal® Coating outperformed the competition with no visible red rust. ITW

7. Approved for High Velocity Hurricane Zones (HVHZ)! Great for securing Hurricane shutters Superior load carrying capacity than traditional “blue screws” Powers’ Patented Perma-Seal® coating provides excellent corrosion resistance in extreme weather environments.

8. 1. Using the included 5/16” Tapper+ SDS Bit, drill a hole into concrete. 2. With a #3 bit tip or 5/16” hex socket depending on head style mount the anchor into the socket 3. Drive the anchor with an impact wrench (max 115 ft-lbs.) Recommended DEWALT DCF895C2 4. After installation notice the on the head. The head diameter is the same size as the ¼” Tapper+. Note the fast install time and minimal effort during installation due to the coarse thread.

9. *Only available in button head style

10. For Ordering Information Download the Brochure here: http://www.powers.com/pdfs/catalogs/49159_tapperplus_hi.pdf *Bronze available by special order

11. Installation Kit Includes: #3 Philips Impact Power Bit 5/16” Impact Ready Nut Driver 5/16“ x 6” SDS+ Tapper+ Bit 5/16“ x 8” SDS+ Tapper+ Bit Robust Powers case

12. Available in a choice of 4 different Head styles and a variety of colors to suit your application. Bonus SDS Tapper+ Bit comes with every box of Tapper+® Xtreme screw anchors!! Contact your local Powers representative today! Trim Flat Trim Hex Hex Flange Flat