1. Michael Long– Eagle Project - Exhibit D-1 Plans/Drawings – Top View
All Drill Holes marked from left side due to differences in board lengths.
8 ft.
7 ft.
4 ft.
1 ft.
Approximately 16in. – Composed of 8 [2” x 4”x 8’] boards bolted together with 3/8” Washers and Nuts
Spacer = Washer + Nut Washer
2” x 4” x 28” End Cap Piece (To be cut to actual length after main unit is bolted together)
3/8” x 36” Metal Threaded Rods
1/19/08
Michael Long Eagle Project Plan 20

2. Michael Long– Eagle Project - Exhibit D-2 Plans/Drawings - Front View
2” x4” x 8’
7 ft.
Brace “A”
4 ft.
1 ft.
19”
Brace “B” 4” 4”
Brace “C”
18 in.
Center Line
= 2-1/2’ x # 8 screw 9”
2” x 4” Side Braces
Concrete Mix
Approximate Ground Level
6” Round Hole Evacuated for Legs. Concrete poured into hole and water added.
Note: There will be four legs on each bench
1/19/08
Michael Long Eagle Project Plan 21

3. Eagle Project - Exhibit D-3 Plans/Drawings - Side View
(With End Piece Removed For Clarity)
Approximately
16 inches
Brace “A” About 16”
Threaded Rods 4”
Spacers =
Brace “B” About 16” 2” 4”
Washer +
Nut +
Washer
Brace “C” Exactly 14” Wide 4”
4”x4”x2’
Bench Legs
2”x4” Side Braces
Approximate Ground Level 7“
14“
Approximately

4. Eagle Project - Exhibit D-4 Plans/Drawings – Cutting Patterns
Drilling Pattern # 1 – For 48 Seat Rails –-- Material = [2 x 4 x 8’s]
7 ft.
4 ft.
1 ft.
Note: Make all measurements from the left edge.
Cutting Pattern # 2 – For 24 Legs Material = [4 x 4 x 8’s]
= saw cut
~ 48 in.
~ 48 in.
23 in.
23 in.
23 in.
23 in.
Leg
Leg
Leg
Leg
Leg
Leg
Leg
Leg

5. Eagle Project - Exhibit D-5 Plans/Drawings – Cutting Patterns
Cutting Pattern # 3 – For 12 End Caps & 12 Leg Brace C --- Material = [2 x 4 x 8’s]
18 in.
18 in.
14 in.
14 in.
End Cap
End Cap
End Cap
Leg Brace “C”
Leg Brace “C”
End Cap
Cutting Pattern # 4 – For 24 of each Leg Brace A & B Material = [2 x 4 x 8’s]
16 in.
16 in.
16 in.
16 in.
Leg Brace “B”
Leg Brace “A”
Leg Brace “A”
Leg Brace “B”
Leg Brace “B”
Leg Brace “A”
Leg Brace “A”
Leg Brace “B” 24

6. Measuring team

7. Michael Long Eagle Project Plan
1/19/08
Michael Long Eagle Project Plan

8. Cutting and Drilling Team

11. Bench Assembly Team