1. Current Research Experimental and numerical modeling of flow in a levee breach Experiments and simulation of sandbag motion at a levee breach Measurement and simulation of dam break flows Experimental study of erosion due to levee overtopping

2. Graduate students: S. Yusuf, M. Elkholy, C. Riahi-Nezhad, L. Larocque, J. Feliciano, L. Alva-Solari

3. Experimental and numerical modeling of flow in a levee breach

4. Objectives To obtain detailed 3-D flow field from measurements in a model levee breach To measure flow field around submerged structures To simulate complex 3-D flow field in a levee breach and a flooded urban area using the VOF model

5. Breach Dimensions 465 ft 200 ft 45 ft S W N E Source: IPET Report 2, https://ipet.wes.army.milhttps://ipet.wes.army.mil

6. Physical Model Scale 1:50 (model: real-life system/prototype) ModelPrototype Breach width9.3 feet465 feet Canal width4 feet200 feet Flooded area140 Sq. Ft8 acres

7. Flow Physical Model Layout 900 GPM Model Scale 1:50

8. Model Construction

9. Flow Model Scale 1:50 Aerial View of the Physical Model

10. Sampling rate (HZ) …………………..……. 0.1 to 50 Sampling Volume (CC) ………………..…. 0.09 Dist. To sampling volume (cm) ……….. 5 Resolution (cm/s) ….………………………. 0.01 Prog. Velocity range (cm/s) ………..….. 3, 10, 30, 100, 250 Accuracy ………………………………………… 1% of measured velocity, 0.25 cm/s Maximum depth (m) ………………………. 60 ADV Source: http://www.sontek.com/download/brochure/adv.pdf Velocity measured using 16 MHZ SonTek MicroADV

11. UVP An Ultrasonic Velocity Profiler (UVP) transducer transmits a short emission of ultrasound, which travels along the measurement axis. When the ultrasonic pulse hits a small particle in the liquid, part of it scatters on the particle and echoes back. Figure 1: This diagram explains the process of data collection by the UVP. The UVP is placed at an angle and reflection of the particles and from the bottom creates a velocity profile.

12. Measurements (X7,Y4) and (X7,Y5)

13. (X7, Y4)(X7, Y5) These plots show the velocity in the x direction. Vx Velocity Distribution (X7,Y4) and (X7,Y5)

14. Measurement (X24,Y9) and (X24,Y13)

15. Velocity Profiles for X24-Y9 and X24-Y13

16. Breach Geometry in Gambit 2.4.6 Inlet (Blue) Outlet (Red) Houses (solid Blocks) Arrows shows the direction of flow

17. Mathematical Model General Ansys Fluent 6.3.26 used for modeling of levee breach flows Solver: Pressure based Multiphase model: VOF (Implicit scheme) Turbulence model: k-epsilon Grid specification Boundary layer : meshed at the bottom of the channel Grid: hexahedral with size = 2 cm

18. Plane X-24 (Gray color)

19. Velocity at 0.12 m from the Bottom

20. Ongoing and Future Research Flow measurements around model buildings using UVP Comparison of computed and measured velocity distributions Characterization of turbulence over irregular topography Inclusion of erosion and deposition of channel bottom and sides

21. Methods for the closure of 17 th Street Levee Breach

22. Without Barrier

23. Tracking Sand Bag Motion in a Levee Breach using DPTV Technique

24. Developing a visual technique for tracking the motion of the sand bags and plotting their trajectories. Determining the three-dimensional velocity components of the sand bags. Formulating relationships between the sand bag size and shape and flow parameters. Determining optimum sand bag size, and more efficient procedures for levee closure.

25. Trials for breach closure Source: http://www.usace.army.mil/katrina-images/NO-A-09-04-05_0072.jpg

26. Katrina Model Flow 2.83 m 1.22 m 3.05 m

27. Recording device SpecificationGRAS-03K2M/C Maximum resolution640(H) x 480(v) Pixel size 7.4  m x 7.4  m Maximum Frame rate200 Fps Shutter speed0.02 ms to 10s Transfer rate100 Mbit/s Area covered at distance of 1.0 m 370 x 270 mm 2 Angle of view221627

28. The Model Sand bags Plan view Elevation 14.525.436.354.4108.8 21.826.329.633.942.8 4,0007,00010,00015,00030,000 Weight (gm) Equivalent Dia. (mm) Equivalent prototype weight (Ib) 1:50

29. 3-D Stereoscopic System Image Plane Lens Plane Water surface Camera-axis 2 f d z x dz dx o a a1o1o2a2 x1x1 x2x2 x1x1 x2x2 S Camera-axis 1

30. Centroiding Testing of extraction of sandbag in stationary flow After Extraction

31. x x x U/S Levee D/S Levee Bed Elevation Contour Map for the Katrina Model Ditch x x Canal 9.70 – 16.1 16.1 – 19.1 19.1 – 22.3 22.3 – 25.7 cm Datum: Top of the U/S levee 12345

32. Tracking Sandbag using DPTV

33. Trajectories of 10,000 Ib sandbag at different locations (Plan view) 1 2 4 3 5

34. Trajectories of 10,000 Ib sandbag (vertical direction) Time (sec) Location (3) Time (sec) Location (1)

35. Ongoing and Future Research Understanding the general mechanics of sand bag motion. Formulating relationships between the sand bag size and shape and flow parameters. Determining the optimum size of sand bags and procedures for levee breach closure.

36. Experimental and Numerical Investigations of Dam-Break Flows

37. To measure the instantaneous velocity over time for a dam break experiment. using an Ultrasonic Velocity Profiler (UVP) To conduct LES simulation of a dam break wave. To compare the measured and simulated flow field Figure: Experimental dam break set up. Notice the left hand side of the dam is filled with water up to 25 cm.

38. Flume: 7.67 m long, 25 cm deep, 18 cm wide, and 3.5% slope. UVP placed at 45 deg. (schematics shown below). UVP start measuring velocity as dam is lifted Experimental Set up UVP Probe UVP probe facing upward to determine water level over time UVP Probe UVP probe facing downward to find the velocity profile at the bottom of a dam break wave Experiment 1 Experiment 2

39. A numerical grid with two separate volumes (water and air) was generated using Gambit, a grid generating program. The numerical simulation was conducted using FLUENT. Large Eddy Simulation (LES) and Volume of fluid (VOF) models were used. Numerical Set-up The grid used in the numerical simulation. The blue grid indicates the water and the other portion is the air at the initial location. Volume: WATER Volume: AIR

40. Experimental Results The UVP continuously measures the velocity over time and generates a velocity profile at a specified time step. Multiple trials were conducted to compare the repeatability of the experiment. This graph shows the velocity profile measured using a UVP. The two lines represent two separate trials of the experiment. T=1.0s

41. Comparison A comparison between the numerical simulation and the experiment velocity profile on the upstream side of the dam break

42. Additional measurements throughout the model Experimental measurements of flow field including erosion and deposition following dam failure. Simulation of flow field following dam failure including erosion and deposition of bottom material Ongoing and Future Research

43. Levee Breach due to Overtopping

44. Objectives To understand and identify the parameters that govern the erosion and headcut formation during the overtopping of a levee. To conduct laboratory experiments overtopping small-scale dikes in a flume. To collect and evaluate the data and improve/modify breach models.

45. Dike and Flume Dimensions DIKE DIMENSIONS Height0.22 m Top0.09 m Side slope2H:1V FLUME DIMENSIONS Length6.5 m Width0.46 m Height0.26 m

46. MaterialD50 Specific Gravity LLPL Sand 30400 μm2.69 --- Kaolin0.6 μm2.5981.1%33.6% Silt 10622 μm2.65 --- Silt 25049 μm2.65 --- Material

47. Soil Composition NoSOILBX30Kaolin Silt 106 Silt 250 γdγd ωoωo No Passes with Roll Flow Rate (L/s) Exp 1Soil 185%15% --- 113 lb/ft 3 12%100.24 Exp 2Soil 270%15% --- 126 lb/ft 3 10%150.24 Exp 3Soil 380%10% --- 126 lb/ft 3 10%180.24 Exp 4Soil 4 --- 10%72%18% 108 lb/ft 3 13.5%153.9

48. Compaction DATA Weight of the roll 20.5 Kg Soil Layer Thickness 0.05 m No Passes per Layer 10, 15, 18 Compaction obtained 80% to 95% of γ d

49. Instrumentation DescriptionQuantity Water level gauge downstream01 Water level gauge upstream01 Video cameras04 UVP sensor for velocity measurement (being implemented) 04 Data acquisition (being implemented)01 Weir01 Timer01

50. Instrumentation UVP Sensor Upstream UVP Sensor Downstream Top Video Camera Front Video Camera Video Camera Data Acquisition

51. Levee Breach Experiments 1, 2 & 3 1 2 3 EROSION ON THE DOWN STREAM FACE OF THE DIKE HEADCUT UNDERMINING RESERVOIR FLOW MAIN ELEMENTS OF THE PROCESS: - SOIL PROPERTIES - GEOMETRY - FLOW CHARACTERISTICS

52. Headcut Experiment 4 FRONT VIEW TOP VIEW 0.02 m 1.5H:1V HEADCUT GEOMETRY

53. Headcut Experiment 4 (Front View) 30s 0s 1’ 2’ 2’30” 2’52” 2’53”3’4’

54. Headcut Experiment 4 (Top View) 12 3 4 5 6

55. Hydrograph for Headcut Experiment

56. Ongoing and Future Work a.Systematically vary non-dimensional numbers involving soil properties, levee geometry and flow properties in experiments. b.Understand and evaluate the scale effect. c.Focus on the effect of cohesion on the breach process. d.Conduct experiments at larger scales.