1. IPv6-The Next Generation Protocol RAMYA MEKALA UIN:01008672

2. What is IPv6  Also known as IPng (next generation)  A new version of the Internet Protocol, which is primarily designed to extend address space.  It is a Network layer protocol used for packet-switched internetworking and provides end-to-end datagram transmission across multiple IP networks.

3. Difference between IPv4 and IPv6  Expanded address space  Header Format Simplification IPv6 header is twice as long (40 bytes) as IPv4 header without options (20bytes)  No checksum at the IP network layer  No hop-by-hop segmentation  64 bits aligned  Authentication and Privacy Capabilities  No more broadcast, only Multicasting  Mobility  Privacy

4. IPv6 packet Header

5. IPv6 Addressing  Three types  Unicast  Packet delivered to a single interface.  Any cast  Packet delivered to the nearest of a set of interfaces.  Multicast  Packet delivered to all interfaces in a set.

6. Representation of IPv6 address

7. IPv6 Addressing Scope  64 bits reserved for the interface ID  16 bits reserved for the end site  16 bits reserved for each service provider  29 bits reserved for all service providers

8. Migration to IPV6  The current IP-based network will gradually migrate from IPv4 to IPv6.  Signaling interworking will need to be supported between the IPv6 network and the existing IPv4 network.  Mapping of signaling between IPv6 and IPv4 is required.  There are several migration mechanisms from the IPv4 protocol to IPv6 protocol. The following are the most discussed techniques: -Dual stack:to allow IPv4 and IPv6 to coexist in the same devices and networks. -Tunneling: to avoid order dependencies when upgrading hosts, routers or regions. - Translation: to allow IPv6 only devices to communicate with IPv4 only devices.

9. Dual Stack Technique  In this method it is proposed to implement two protocols stacks in the same device.  The protocol stack used for each link depends on the device used at the other end of the link.

10. Tunnelling Techniques

11. Translation Techniques  This technique uses a device, the NATPT (Network Address Translation – Protocol Translation) that translates in both directions between IPv4 and IPv6 at the boundary between an IPv4 network and an IPv6 network.

12. Benefits of IPv6  Improved efficiency in routing and packet handling.  Support for auto configuration and plug and play.  Support for embedded IPSec.  Enhanced support for Mobile IP and mobile computing devices.  Elimination of the need for network address translation (NAT).  Support for widely deployed routing protocols. Aside from the increased address space,IPv6 offers a number of other key design improvements over IPv4.

13. References  Computer Networking a top down approach 6 th edition kurose,Ross.  http://en.wikipedia.org/wiki/IPv6 http://en.wikipedia.org/wiki/IPv6  http://ipv6.com/articles/general/ipv6-the-next-generation-internet.htm http://ipv6.com/articles/general/ipv6-the-next-generation-internet.htm

14. QUERIES ? ? ?