1. ECE 1201
Engineering Lab II

2. Taaruf Nor Farahidah Za’bah Room number : E2-2-13.12
Phone number :
address :
The lab technicians are
Br. Ahmad Suhairi and Br. Rosley Mahadi
Course website:

3. Tentative Week Experiment No. (Title)1
Introductory class – Briefing on the organization of the course 2
Introduction to PSPICE 3
PSPICE 4
Experiment No. 1 & 2
(Diode Characteristics & Zener Diode Characteristics)
5 & 6
Experiment No. 3
(Wave Rectifier & Clipper Circuit)
7 & 8
Experiment No. 4
(BJT Characteristics & Common-Emitter Transistor Amplifier)
9 & 10
Experiment No. 5
(BJT Biasing Circuits) 11
Experiment No. 6
(MOSFET - Common Source Amplifier) 12
Experiment no. 7
(Inverting and Non-Inverting OP Amp)

4. Assessment
Pre-lab
10 %
Quiz
15 %
Final Test
30 %
Lab Report
45 %

5. Safety
Please wear Kulliyyah jacket and covered shoes – NO SLIPPER. Otherwise, you will be asked to leave the lab.
Power must be switched off whenever an experiment or project is being assembled, disassembled, or modified.

6. Tidiness
When the experiment has been satisfactory completed and the results approved by the instructor, the students may disconnect the circuit and return the components and instruments to the locker tidily.
Chairs are to be slid in properly.
DO NOT WRITE anything on the table

7. Pre-Lab Questions and Preparation
Please complete the pre-lab questions before each lab sessions.
It serves as guidance for you while doing your experiment
Read the entire experiment and research any required theory beforehand. Many times an experiment takes longer that one class period simply because a student is not well prepared.
The experiment is performed in pairs (max=3 students per group) but the final exam is performed individually
One group = one lab report

8. Lab Reports Reports have to be handwritten for submission.
Writing should appear on one side of each sheet only.
The students’ name & matric number, section number, lab session and the lecturer’s
Please indicate the author of each section in your report.
This must be followed in the middle of the sheet by:
The course code
The experiment number
The title of the experiment
The date on which the student carried out the experiment.

10. Report format and evaluation

11. Preparation for PSPICE Tutorial
Tentative Week
Experiment No. (Title) 1
Introductory class – Briefing on the organization of the course 2
Introduction to PSPICE – Tutorial 1 3
PSPICE - Tutorial 2
Please download the PSPICE software and its tutorial from the website into your laptop.
One group will need only need one laptop

12. Preparation for PSPICE Tutorial
Download 16.6_OrCAD_Lite_Capture&PSpice_Products.zip from the any computer in the lab
It is a zipped file, you have to extract the files into a designated folder
Once you have extracted, go to Disk 1 and look for SETUP (it is an application file) to install the software.

13. Introduction to Lab Equipment
Bread board and its connections

15. Function Generator
To create AC signals such as Sine-Wave, Triangular Waves etc
The user can alter its frequency and amplitude
Example of a function generator

16. Oscilloscope An equipment to show the obtained result. Has 2 channels
One for input signal
One for output signal

17. DC power supply
To provide DC supply to your circuit which you can measure using digital multimeter