1. Principle of the process Design For Manufacturing (DFM)
Structure
Process modeling
Defects
Design For Manufacturing (DFM)
Process variation
Metal forming
Drawing
Handout 8 c

2. Bulk Drawing: Engineering Analysis
1. Introduction
In the bulk deformation processes, drawing is an operation in which the cross section of a bar, rod, or wire is reduced by pulling it through a die opening, as shown in Figure 1.
Handout 8 c

3. Extrusion Drawing Has pushing force Has pulling force Figure 1 here
Handout 8 c

4. Bulk Drawing: Engineering Analysis
2. Objectives of the Analysis
Rolling process
Drawing process
Torque (force)
Power
Velocity (productivity)
Max draft
Pulling force
Power
Pulling velocity
Max draft
Handout 8 c

5. 3. Mechanics Phenomenon
There is a tensile stress due to pulling force, but compression still plays a significant role since the metal is squeezed down as it passes through the die opening.
Handout 8 c

6. Friction between work and die
4. Parameters
r=(A0-Af)/A0
r: area reduction
A0: initial area of work
Af: final area
d=D0-Df, draft
Drawing stress
Contact length
Die angle
Friction between work and die
Force
Handout 8 c

7. 5. Drawing stress, drawing force, power
Accounts for inhomogeneous deformation
Handout 8 c

8. 5. Drawing stress, drawing force, power
Handout 8 c

9. Maximum power < Allowable power of a drive system
Yield stress
6. Limit of Drawing
Maximum power < Allowable power of a drive system
If not, material goes into plastic region & no “drawing” occurs, just “elongation”
Maximum stress < Yield stress
- If done, as Reduction , draw stress also
Entire reduction not done in a single pass (done in steps)
Handout 8 c

10. 6. Finding Max draw stress & Max reduction (1 pass)
Assumption: no friction, no strain hardening (n=0), no redundant work (perfectly plastic)
Max. draw stress = Yield Strength
Also,
because (n=0)
Handout 8 c

11. Handout 8 c

12. Example
Wire stock of initial diameter = in. is drawn through two dies each providing a 0.20 area reduction. The staring metal has a strength coefficient = 40,000 lb/in.2 and a strain hardening exponent =0.15. Each die has an entrance angle of 12o, and the coefficient of friction at the work-die interface is estimated to be The motors driving the capstans at the die exists can each deliver 1.50 hp at 90% efficiency. Determine the maximum possible speed of the wire as it exits the second die.
Handout 8 c

13. Handout 8 c

14. Handout 8 c

15. the second draw die could be powered by a higher horsepower motor; or
From this calculation, the velocity of the second die is the limiting velocity. That is to say, the velocity of the whole system should take 3.47 ft /s. As a result,
the first operation would have to be operated at well below its maximum possible speed; or
the second draw die could be powered by a higher horsepower motor; or
the reductions to achieve the two stages would be reallocated to achieve a higher reduction in the first drawing operation.
Handout 8 c