2. Terminology Quiz Click here to start

3. Centre BitCountersink Bit Counter bore BitSpade Bit What is the correct name for the tool shown ?

4. What is the correct name for the tool shown ? A Jack PlaneA Combination Plane A Rebate PlaneA Moulding Plane

5. What is the correct definition of the word Ergonomics? Relating to the enjoyment or study of beauty. Describes an object or a work of art that shows great beauty The scientific study of people and their working conditions, especially done in order to improve effectiveness: The study and recording of the physical properties of the human body

6. Which tool would be used to produce Knurling?

7. What is the correct name for the recess machined to allow the head of a bolt to sit below the surface of the work piece? Groove Countersink Counterbore Chamfer Fillet

8. Jointing BlockFlat Pack Fixing Knock Down FixingBlock joint What is the generic name for this type of joint?

9. Jack PlaneCombination Plane Rebate PlaneCompass Plane What is the correct name for the tool shown ?

10. Jack PlaneCombination Plane Rebate PlaneCompass Plane What is the correct name for the tool shown ?

11. Groove Rebate Moulding Chamfer What is the correct name for the “Slope” on the edge of this kitchen worktop? Fillet Radius Counter bore

12. Groove Rebate Moulding Chamfer What is the correct name for the “Slot” cut in the edge of this piece of wood? Fillet Radius Knurling

13. Biscuit Cutter Cordless Drill Moulder Router What is the correct name for the power tool shown above? Angle Grinder Orbital Sander Jigsaw

14. A Groove A Rebate A Moulding A Chamfer What is the correct name for the “shaping” along the edge of this piece of mahogany? A Fillet A Radius A Curve

15. Fitted FurnitureFlat Pack Furniture Knock Down FurnitureBoxed Furniture What is the generic name for this type of Furniture?

16. On the diagram to the left indicate where a fillet has been added to increase the strength of the casting

17. When driving in nails or screws near the edge of a piece of wood it is a good Idea to pre-drill a hole to prevent the wood splitting. This is called a ? A CountersinkA Pilot Hole A CounterboreA Fillet

18. Aesthetics Shape SizeProportionPatter n Texture Form Symmetry Which one of these areas would not be considered part of the field of Aesthetics Colour Weight

19. Groove Rebate Moulding Chamfer What is the correct name for the pattern being cut into this Centre Punch. Fillet Radius Knurling

20. What is the correct definition of the word Anthropometrics? Relating to the enjoyment or study of beauty. Describes an object or a work of art that shows great beauty The scientific study of people and their working conditions, especially done in order to improve effectiveness: The study and recording of the physical properties of the human body

21. Well Done Quiz Completed

22. Wrong Click here to try again 