1. PJ2T Flag Receiving Antenna
SIGNALS ARRIVAL
PJ2T Flag Receiving Antenna
There is a free-floating egg insulator at each corner
29’ 6
The flag is constructed with two lengths of #14 wire (top and bottom), each 43 feet long. They are each soldered to the 18:1 transformer at one end, and through the 910-ohm resistor on the other end, with an egg insulator included for strain relief. Total length of wire required is 86-feet.
The vertical wire section is 14-feet long, and start 6-feet above the ground. There is a sliding end insulator at each corner.
The feed transformer and terminating resistor are each anchored to the mast 13 feet above ground.
The 18-foot RG-8X feedline connects to the transformer, then is taped to the mast below the feedpoint and run to the ground. It connects to the preamplifier, which in turn is connected to a 50-foot length of RG-8X wound 8 turns around four FT ferrite cores in a 1.5-foot coil.
Each fiberglass mast section is 44 inches high when stacked, and the 6-section masts are 22-feet high. Each mast section is numbered (1-6). They are 30 feet apart, and are guyed at the top of the fourth fiberglass mast section (14’ 8” off the ground). Each of the six guy ropes must be at least 25-feet long, but are cut to 40-feet to allow guying onto random bushes as available. 6
21.5”
Guy ring
~900-ohm resistor
18:1 transformer 5 5
Guy ring
Guy rope >25-feet long
14’ 4 4
23.75”
23.75”
22’ 3 3
18’ RG-8X 2 2
29’
27” 6’ 1
44”x 6 Fiberglass Mast Sections 1
Preamplifier
K8ND a
8 turns on four (4) FT toroids

2. PJ2T Flag Receiving Antenna Feed Details
Wire
RG-8X Feedline, 18-feet. Tape to mast, from feedpoint to ground.
18:1 transformer
RG-8X Feedline to shack, with +12V for preamplifier
Wire
Choke: 8 turns RG-8X through four FT ferrite cores.
Fiberglass Mast
ECP-1 10 dB Preamplifier
Tape Feedline to mast near ground.
The 18:1 matching transformer and the 10dB gain remote ECP-1 preamplifier system are products of Lance Johnson Engineering ( Any 18:1 pennant/flag matching transformer or preamplifier may be used. A preamplifier is required, as these antennas are deaf without one.
K8ND a

3. PJ2T Flag Receiving Antenna Block Diagram
18:1 Transformer (On Mast)
18-feet RG-8X down mast to ground.
ECP-1 Preamplifier (On Ground)
8-turn coaxial choke on four FT ferrite cores.
~550-feet RG-8X NOTE: This feedline has +12 Volts on it for the preamplifier.
+12 VDC
ECP-1 Power Box (In Shack)
K1FZ KB-4 50-Ohm Splitter (In Shack )
K8ND a