1. Ax AxBot is a robot that puffs balloon as using its arm as ax.

2. Assembling 1. Fix DC Motors and Motor Frames with bolts.

3. Assembling 2. Fix Motor Frame that is fixed to DC Motor to Main Frame with bolts.

4. Assembling 3. Fix Servo Motor and Motor Frames with bolts.

5. Assembling 4. Fix Motor Frame that is fixed to Servo Motor to Main Frame with bolts.

6. Assembling 5. Fix 35mm Support to Main Frame with bolts.

7. Assembling 6. Put Battery Case to Support that is fixed to Main Frame and fix with nuts and 35mm Support. Then fix Controllable nut to 35mm Support.

8. Assembling 7. Fix 35mm Support to Main Frame with bolts. Then fix Controllable nut to 35mm Support.

9. Assembling 8. Connect Wheel Guide to L-type 2x2 Frame with 20mm Support. And Fix L-type 2x2 Frame to Main Frame with bolts and nuts.

10. Assembling 9. Connect Small 3 Frames and Option Frame with bolts and nuts then fix to Wheel Guide.

11. Assembling 10. Connect Wheel Guide and Middle Frame then put Small 4 Frame and Small 8 Frame on Middle Frame then fix with bolts and nuts.

12. Assembling 11. Put a paper clip between Small 8 Frame and Small 3 Frame and fix with 3x10 bolts then cut end of paper clip sharply with a nipper.

13. Assembling 12. Insert a paper clip to Wheel Guide of fixed arm to Servo Motor axle.

14. Assembling 13. Fix 20mm Supports to Option Frame then fix to Main Frame with bolts and nuts.

15. Assembling 14. Insert Wheels to DC Motor axle.

16. Assembling 15. Fix CPU Board and DC Motor Drive Board with bolts and nuts.

17. Assembling 16. Connect Remocon Receiving Board and CPU Board with Motor Frames.

18. Assembling 17. Connect 40mm Support and 7mm Support then fix to CPU Board.

19. Assembling 18. Fix 7mm Support to Middle Frame with bolts then put Small 3 Frame on 7mm Support and fix with nuts.

20. Assembling 19. Put Middle Frame that fixed eye brow, newly prepared Middle Frame and Option Frame on Support that is fixed to CPU Board and fix with bolts.

21. Assembling 20. Insert Caterpillar Wheel Guides between Middle Frame then put Option Frame on Support that is fixed to CPU Board and fix with bolts to make a face.

22. Assembling 21. Fix AxeBot face to Support that is fixed to Option Frame with bolts.

23. Assembling 22. Connect Power cable of Battery Case to Power Connector of CPU Board. Connect DC Motor cable to DC Motor Drive Board A, B.

24. Assembling 23. Connect 3 Pin Cable to OUT Port 1, 2, 3, 4 of CPU Board and DC Motor Drive Board 1, 2, 3, 4. Connect Servo Motor cable to OUT Port of CPU Board.

25. Assembling 24. Completed AxeBot.

26. Set starting point of servo motor Set starting point of servo motor Setting Position of Starting Point Radius of Rotation