Download presentation
Presentation is loading. Please wait.
Published byJalen Nightengale Modified over 9 years ago
1
9.1 Chapter 9 Using Telephone and Cable Networks for Data Transmission Copyright © The McGraw-Hill Companies, Inc. Permission required for reproduction or display.
2
9.2 9-1 TELEPHONE NETWORK Telephone networks use circuit switching. The telephone network had its beginnings in the late 1800s.
3
9.3 9-1 TELEPHONE NETWORK The 19 th century telephone network is referred to as the plain old telephone system (POTS), was an analog system using analog signals to transmit voice.
4
9.4 Figure 9.2 Switching offices in a LATA
5
9.5 The tasks of data transfer and signaling are separated in modern telephone networks: data transfer is done by one network, signaling by another. Note
6
9.6 Figure 9.4 Data transfer and signaling networks
7
9.7 9-2 DIAL-UP MODEMS Traditional analog telephone lines can carry frequencies between 300 and 3300 Hz, giving them a bandwidth of 3000 Hz. All this range is used for transmitting voice, where a great deal of interference and distortion can be accepted without loss of intelligibility.
8
9.8 Figure 9.6 Telephone line bandwidth
9
9.9 Data is noise sensitive Voice is not noise sensitve
10
9.10 Modem stands for modulator/demodulator. Note
11
9.11 Figure 9.6 Telephone line bandwidth
12
9.12 Figure 9.7 Modulation/demodulation
13
9.13 Figure 9.8 The V.32 and V.32bis constellation and bandwidth
14
9.14 V.32 & V.32 BIS V.32 32 Levels (5 bits per signal) – 1 redundant bit and 4 data bits per baud. (2400Hz * 4 bits/buad) V.32 BIS 128 Levels (7 bits per signal) – 1 redundant bit and 6 data bits per baud (2400Hz * 6 bits/baud)
15
9.15 V.90 Requires a digital link which came from an ISP The ISP sends a quality signal to the modem, this signal has no quantization error. This allows for 56 Kbps, downstream The signal upstream must be quantized limiting the bandwidth to 33.6 kbps Aka asymmetric V.90
16
9.16 Downstream Nyquist rate for V.90 Bit-rate = 2 * Bandwidth-Hz * 7bits/signal The phone line provided 4000Hz of bandwidth from the local link to the ISP 1 bit of the 8bit word is for error detection, leaving 7 bits of data per word. 56Kbps total downstream rate
17
9.17 Upstream V.90 Due to noise introduced by the quantization of the analog signal to the ISP, (refer to Fourier Analysis and Shannon's Sampling Theory)
18
9.18 9-3 DIGITAL SUBSCRIBER LINE After traditional modems reached their peak data rate, telephone companies developed another technology, DSL, to provide higher-speed access to the Internet. Digital subscriber line (DSL) supports high-speed digital communication over the existing local loops.
19
9.19 ADSL is an asymmetric communication technology designed for residential users; it is not suitable for businesses. Note
20
9.20 The existing local loops can handle bandwidths up to 1.1 MHz. Note
21
9.21 A filter is used to limit your phone bandwidth to 4000Hz, otherwise the copper wire can go to 1.1MHz.
22
9.22 ADSL is an adaptive technology. The system uses a data rate based on the condition of the local loop line. Note
23
9.23 Line Condition Factors Length of line, Attenuation Noise Distortion An adaptive technology that adjusts to bandwidth to the quality of the local loop.
24
9.24 Figure 9.10 Discrete multitone technique
25
9.25 256 channels 1 for voice Up to 255 for data Each channel is 4312 Hz.
26
9.26 Figure 9.11 Bandwidth division in ADSL
27
9.27 Channel Rate Each data channel has a maximum capacity of 4000 Hz * 15 bits/buad Not all the frequency bandwidth is used to allow for guardbands.
28
9.28 Upstream - Downstream 25 upstream channels = 24 upstream data channels + 1 data control stream channel 225 downstream channels = 224 downstream data channels + 1 data control stream
29
9.29 ADSL Max upstream = 1.44 Mbps Max downstream = 13.4 Mbps Sorry, the adaptive capability limits you to much less due to noise, attenuation, and distortion.
30
9.30 Figure 9.12 ADSL modem
31
9.31 Figure 9.13 DSLAM
32
9.32 Table 9.2 Summary of DSL technologies
33
9.33 9-4 CABLE TV NETWORKS The cable TV network started as a video service provider, but it has moved to the business of Internet access. In this section, we discuss cable TV networks per se; in Section 9.5 we discuss how this network can be used to provide high-speed access to the Internet. Traditional Cable Networks Hybrid Fiber-Coaxial (HFC) Network Topics discussed in this section:
34
9.34 Figure 9.14 Traditional cable TV network
35
9.35 Communication in the traditional cable TV network is unidirectional. Note
36
9.36 Figure 9.15 Hybrid fiber-coaxial (HFC) network
37
9.37 Regional cable head office can serve up to 400,000 subscribers Each distribution hub can service upto 4000 subscribers. Each coaxial cable can service 1000 subscribers.
38
9.38 Communication in an HFC cable TV network can be bidirectional. Note
39
9.39 9-5 CABLE TV FOR DATA TRANSFER Cable companies are now competing with telephone companies for the residential customer who wants high-speed data transfer. In this section, we briefly discuss this technology. Bandwidth Sharing CM and CMTS Data Transmission Schemes: DOCSIS Topics discussed in this section:
40
9.40 Figure 9.16 Division of coaxial cable band by CATV
41
9.41 Each tv broadcast uses 6MHz, and cable provides 80 stations
42
9.42 Downstream data are modulated using the 64-QAM modulation technique. Note
43
9.43 The theoretical downstream data rate is 30 Mbps. Note
44
9.44 Upstream data are modulated using the QPSK modulation technique. Note
45
9.45 The theoretical upstream data rate is 12 Mbps. Note
46
9.46 Bandwidth Sharing The bandwidth is shared by 1000s of subscribers using FDM
47
9.47 Figure 9.17 Cable modem (CM)
48
9.48 Cable modem (the user) Cable modem transmission system (cable provider)
49
9.49 Figure 9.18 Cable modem transmission system (CMTS)
Similar presentations
© 2024 SlidePlayer.com. Inc.
All rights reserved.