1. [LAB 1] Getting Start  Introduction  Getting Start  Guiding Materials

2.  配件 :  Beagle Bone  USB OTG cable  MicroSD Card  MicroSD Card adaptor BeagleBone Rev A6a

4. Getting Start  Connect to PC with Windows7

5. Getting Start  Check Storage device

6. Getting Start  Install the driver: Bone_DRV or Bone_D64  It’s going to pop out an error message  Change the language of system to English.  Change back after installed.

7. Getting Start  Default mode when BeagleBone connect to PC via USB cable is FlashDrive mode.  Switch to Network mode after Driver has been installed by “Eject” function.

8. Getting Start

10.  Launch Bone101 introduction  Connect to address 192.168.7.2:80  Launch Cloud9 IDE with Chrome or FireFox  Connect to IP address 192.168.7.2:3000

11. Getting Start  Bone101

12. Getting Start  Cloud9 IDE

13. Guiding Materials  BeagleBone System Reference Manual  BeagleBone Schematic  http://beagleboard.org/bone  http://circuitco.com/support

14. Guiding Materials  BeagleBone System Reference Manual

15. Guiding Materials  BeagleBone Schematic

16. Guiding Materials  http://beagleboard.org/bone

17. Guiding Materials  http://circuitco.com/support

18. Example 1  Drive LED onBoard USR 2 、 USR 3  Programming in JavaScript  “require (’Bonescript’)” for including Library in need.

19. Example 1  Drive LED onBoard USR 2 、 USR 3  Programming in JavaScript  “require (’Bonescript’)” for including Library in need.

20. Example 1