1. 1600 Series Operation (See Installation and Operation Manual for detailed instructions)

2. FoamPro 1600 Series Fully automatic Class A foam ONLY
Proportions between 0.1% to 1%
Flowmeter standard
(1", 1-1/2" or 2" tee)
Operators control panel

3. Electronic Direct Injection Proportioner
Foam
Tank
Line Strainer
Water
Tank
Pump
Check
Valves
Flowmeter
Multiple
Discharges

4. Features And Operations
Controller includes:
Operating instructions
On/Off switch
Injection rate control
Adjustable from 0.1%-1.0%
System Status Light

5. Features And Operations (cont.)
System Status Light Codes:
Light flashes then goes out
System ready to operate
One flash per second
Simulated flow mode engaged
Remove power; disengaged automatically
Solid light
No concentrate
Two flashes per second
Concentrate level low
5 flashes per second
Electrical error

6. Features and Operations (cont.)
Motor driver module
Simulated flow momentary switch. Up once, engages. Up again, disengages
Circuit breaker switch “UP” for normal operation

7. Purging Air Enter “SIMULATED FLOW” Valve to “CAL/FLUSH”
Turn panel switch “ON”
Run pump until concentrate flows from dump line

8. Purging Air (cont.) Turn control panel to “OFF” position
Return valve to “INJECT”
Exit “SIMULATED FLOW” by switching momentary switch up

9. Maintenance Foam concentrate strainer Foam concentrate pump
Clean out regularly
If little or no foam concentrate is injected while system is running, check for clogged strainer
Purge air from foam pump afterwards
Foam concentrate pump
Grease fitting every 8 hours of operation