1. 1 The Pringles Cantenna

2. 2 Parts List All-thread, 5 5/8″ long, 1/8″ OD (2) nylon lock nuts (5) 1″ washers, 1/8″ ID aluminum tubing, 1/4″ ID axp 8” long connector to match your radio pigtail 1 1/2″ piece of 12 gauge solid copper wire A tall Pringles can any flavor (Ridges are optional.) Scrap plastic disc, 3″ across (like another Pringles can lid)

3. 3 Tools List Ruler/Tape measure Ruler/Tape measure Scissors Scissors Pipe cutter (or hacksaw or dremel tool, in a pinch) Pipe cutter (or hacksaw or dremel tool, in a pinch) Heavy duty cutters (or dremel again, to cut the all-thread) Heavy duty cutters (or dremel again, to cut the all-thread) Something sharp to pierce the plastic (like an awl or a drill bit) Something sharp to pierce the plastic (like an awl or a drill bit) Hot glue gun Hot glue gun Soldering Iron Soldering Iron

4. 4 Assembly Fist step is to install the panel connector inside the pringles can Fist step is to install the panel connector inside the pringles can Cut a hole 3 3/8” from the closed end of the can Cut a hole 3 3/8” from the closed end of the can Insert the Panel Connector from inside the can and using a glue gun attach it to the can Insert the Panel Connector from inside the can and using a glue gun attach it to the can

5. 5 The Collector Nut Lid Washer Pipe Washer Pipe Washer Pipe-with-Plastic Washer Pipe Washer Nut

6. 6 All Done