1. Thermochemistry of fuel air mixtures
Dr. Primal Fernando
Ph: (081)

2. Combustion process
Thermodynamic aspects of particular type process involving chemical reactions, is called combustion
Usually occurs between fuel and an oxygen carrier (air)
Energy stored in the bonds between constituent atoms of fuel and air (form of internal energy) and in the combustion process it will transformed to new molecules of lower energy level combustion products plus release heat (exothermic reaction)

3. Combustion process Controls the engine power Efficiency
Controls the emissions
Different for SI and CI engines

4. Flames
A flame is a combustion reaction propagate subsonically through space; motion of gas relative to unburn gas is important.
The existence of flame motion implies that the reaction is confined to a zone which is small in thickness compared to the engine combustion chamber.
The reaction zone is usually called the flame front
Flames can be categorized as premixed and diffusion flame (mixed together at same place where the reaction takes place)
Flames also categorized as laminar (mixing and transport done by molecular process) and turbulent (enhanced by eddies and lumps)
Flames also categorized by whether the flow is steady or unsteady

5. Fuel - fossil fuels mainly consists of H and C
By mass
By mass
By volume

6. Chemical equation and conservation of mass
Consider a simple equation
Note: all gasses occupy equal volume for kmol when they are at same pressure and temperature (exactly true for perfect gases, but for other gasses substantially true). Volume occupied by liquid and solids are negligibly small compared to gasses.

7. Chemical equation and conservation of mass
If insufficient O2 presents

8. Necessary Oxygen is mainly obtained by mixing fuel with are
Note: Molar mass of N2 is 28 kg/kmol (28.16), and that for air 29 kg/kmol (28.962)

9. Example
Determine the stoichiometric air/fuel ratio for a petrol approximating to hexane C6H14. Hence deduce the chemical equation if the petrol is burnt in 20 percent excess air, and the wet volumetric analysis of the products
If all the water vapor is present
If products are cooled to an atmospheric pressure and temperature of 1 bar and 15 °C.
Determine also the dry volumetric analysis.
Estimate the chemical equation if only 80% of the air required for stoichiometric combustion is provided
The partial pressure of saturated water vapor at 15 °C is bar

10. Solution
Products

11. Solution Wet volumetric analysis of the Products including N2
Amount-of-substance in the product

12. Solution Amount-of-substance in the product
The wet volumetric analysis

13. Volume fraction=Mole fraction=partial pressure/total pressure
Solution
If products are cooled to an atmospheric pressure and temperature of 1 bar and 15 °C.
Part of water will be condensed, if new amount of water is y, total substance is = y
Volume fraction=Mole fraction=partial pressure/total pressure
Above volumetric analysis repeats base on the total volume of 51.67

14. Solution Determine also the dry volumetric analysis
Analysis is done by assuming no water present, then the amount of substance becomes = 50.79
Above volumetric analysis repeat base on total volume of 50.79

15. Solution Chemical reaction with insufficient air (80%)
When insufficient O2 is given there will be unburned C and H2. H2, However, has a greater affinity for O2. If mixture is not too rich in fuel, it is reasonable to assume that all the H2 will be burnt. Some of C will be burnt to CO and other to CO2.

16. General combustion stoichiometry

17. General combustion stoichiometry
Take, y=b/a = ratio of H2 to C

18. Energy balance
Systems changes from reactants to products (since mass constant, can apply first law for a close system)