1. Sava air bags

2. The new equipment Air Bags Kevlar reinforcing w/ thick, multi-layer rubber shell 24” x 24” positive grip surface w/ safety straps Max load: 27.7 tons Max lift height: 11.8” Specs also listed on the bag 18” x 18” positive grip surface w/ no safety straps Max load: 14.2 tons Max lift height: 8.6” Specs also listed on the bag

3. Air bag’s cont.. 15” x 15” positive grip surface w/ no strap Max load: 10.8 tons Max lift height: 7.0” Specs also listed on the bag *Do not stack more than 2 high*

4. Inflation Accessories

6. Accessories  30 min Scba bottle (4500 psi)  Single-stage Piston Regulator (0-116 psi)

7. Accessories Yellow supply line Red, Blue and Green working lines All lines are: 20’ oil resistant, neoprene rubber Integrated inline shut-off w/ overpressure relief valve

8. Accessories Hand help dual control valve Wye’s

9. Airbag system set up Lay out the system - Airbags - Colored working air lines - Control Valve - Yellow supply line - Regulator - Cylinder - Cribbing - Plywood protectors

10. Airbag System Set-up Connect regulator to Scba bottle Attach yellow supply line to regulator Connect dual head control valve to yellow supply line

11. Airbag System Set-up Attach working lines to control valve, use the “T” if 3 rd line is needed

12. Airbag System Set-up  Attach working lines to Airbags  Gather cribbing and plywood protectors  Place Airbags in desired position  Clear your work area

13. System Use  The system is now set-up and ready to be put to use  Use one FF to set cribbing under load to be lifted  Capture load at all times, Crib as you lift, NEVER rely solely on the airbags to support the load!!  NEVER stack more than 2 bags

14. System Use  Lifting the load:  Select the colored line that feeds the BOTTOM bag  Turn the in-line valve to the ON position  Press the + (plus) button to inflate  Lift bag/ bags to the require height or 116psi max  If utilizing 2 bags stagger lifting bottom bag and top bag  This creates more surface area contact, thus greater stability

15. Lowering the Load  Ensure that the load is stable enough to be lowered  Lift slightly off the cribbing  Remove the first level of cribbing and continue removing as the load is slowly lowered to the ground  Use common sense when placing and removing cribbing and airbags, Watch Out for Pinch Points!!

16. Lower the load Use the – (minus) button on the controller to lower the airbags Remember to open in-line valves if you have them closed Lower the top bag first- then the bottom bag

17. Returning the System to ‘ready ’ Once the airbags are drained and no longer needed, close the SCBA cylinder Bleed remaining air from the system with the + or – buttons Disconnect the lines, controller and regulator Tightly coil airlines Replace all equipment in the grey toolbox Return airbags to the original position on Engine 71