1. F.3 Report Writing Workshop I

2. Limestone What ions does it contain?

3. Calcium ion Carbonate ion Limestone contains

4. How can we test their presence? Calcium ion :Flame Test Carbonate ion : Limestone Delivery tube Lime water Dilute hydrochloric acid

5. Q:How do we recordthe above tests ?

6. What are the features of an experimental report?

7. Task: Compare the two reports and find out the features of an experimental report. (10 mins)

8. An experimental report should contain …….. 1. Title 2. Purpose 3. Chemical Reactions Involved 4. Apparatus and Reagents Used 5. Procedures 6. Observation 7. Conclusion 8. Discussion

9. If we are going to write an experimental report about the test of limestone, we should include…… 1. Title: Chemical test of Limestone 2. Purpose: To identify the chemical composition of limestone

10. 3. Chemical Reactions Involved: Calcium ion Brick red Lilac Bluish green Golden yellow Flame Test Potassium ion Copper ion Sodium ion Other examples:

11. 3. Chemical Reactions Involved: Chloride Dry Cobalt(II) chloride paper Blue to pink Silver nitrate solution with dilute nitric acid  milky Lime water Limestone Delivery tube Dilute hydrochloric acid Water Carbonate Other example:

12. 4. Apparatus and Reagents Used Platinum wire x 1 Test tube x 2 Evaporating dishes x 1 12 M Concentrated hydrochloric acid …… etc

13. 5. Procedures: Task: Write down the procedures of the flame test of calcium ion in a sample.

14. 1. Dip the platinum wire into a test tube of concentrated hydrochloric acid and then heat it in the hottest part of the Bunsen flame until no characteristic colour is shown. 2. After the cleaning, dip the wire into the concentrated hydrochloric acid again and then into the white solid. 3. Heat the solid sample on the wire in the hottest part of the non-luminous flame. 4. Observe and record the colour of the flame. 5. Procedures:

15. Video of flame test

16. Grammar features in an experimental report Past tense Passive voice

17. 1.The platinum wire was dipped into a test tube of concentrated hydrochloric acid and then heated in the hottest part of the Bunsen flame until no characteristic colour was shown. 2.After the cleaning, the wire was dipped into the concentrated hydrochloric acid again and then into the white solid. 3.The solid sample on the wire was heated in the hottest part of the non-luminous flame. 4.The colour of the flame was observed and recorded. 5. Procedures in an experimental report