Download presentation
1
Use Visual Signaling Techniques
Warrior Training Tasks 9 Use Visual Signaling Techniques
2
Sub Task Use Visual Signaling Techniques
Army Warrior Task Use Visual Signaling Techniques
3
Equipment Listing Next Hidden Page will contain Training Support Listing of equipment required for this class. For Classroom COMPUTER PROJECTOR SPEAKERS POWERPOINT SLIDES SCREEN ROSTERS FLASHLIGHT VEHICLE SIGNALING FLAGS
4
Terminal Learning Objective Task, Conditions, & Standards
Agenda Next Page will contain the agenda for the instruction References Terminal Learning Objective Task, Conditions, & Standards Task Steps & Performance Measures Summary Questions
5
Environmental conditions (none) Safety requirements (none)
Administrative Data Next Page will contain Administration Data, make sure hard copy risk assessment is in the training Binder Cell phones/pagers Risk assessment (low) Environmental conditions (none) Safety requirements (none)
6
Terminal Learning Objective
Next Page will contain the TLO for the first subtask Task: Use Visual Signaling Techniques Conditions: Given a requirement to use visual signals while mounted. Standards: Give the proper procedures for each required action.
7
Performance Steps 1. Ensure the Soldiers you are signaling can see you. 2.Perform the visual signals for combat formations, battle drills, and movement techniques as follows: a. Perform formation signals coil and herringbone:
8
Raise one arm above the head and rotate it in a small circle.
Coil Raise one arm above the head and rotate it in a small circle.
9
Herringbone Extend the arms parallel to the ground. Bend the arms until the forearms are perpendicular. Repeat.
10
Performance Steps (cont.)
b. Contact left, contact right, action right, action left, action front (right, left, or rear), air attack, and nuclear, biological, or chemical attack:
11
CONTACT LEFT Extend the LEFT arm parallel to the ground, bend the arm until the forearm is perpendicular. Repeat. CONTACT RIGHT Extend your RIGHT arm parallel to the ground, bend the arm until the forearm is perpendicular. Repeat.
12
Action Left Action Right Extend both arms parallel. Raise your RIGHT arm until it is overhead. Repeat. Extend both arms parallel. Raise your LEFT arm until it is overhead. Repeat.
13
Action Front (LEFT, RIGHT OR REAR), FIGHT ON FOOT, OR ASSAULT FIRE (DISMOUNTED TROOPS).
14
AIR ATTACK Bend the arms with forearms at 45-degree angle. The forearms are crossed. Repeat.
15
NUCLEAR, BIOLOGICAL, OR CHEMICAL ATTACK
16
Performance Steps (cont.)
c. Perform the following movement technique signals: 1.Traveling 2.Traveling Over-watch 3. Bounding Over-watch
17
Extend the arm overhead and swing it in a circle from the shoulder.
Traveling Extend the arm overhead and swing it in a circle from the shoulder.
18
Extend both arms and raise them up and down.
Traveling Over-watch Extend both arms and raise them up and down.
19
Bounding Over-watch: Cover My Move!
Extend one arm to a 45-degree angle. Bend the arm and tap the helmet. Repeat.
20
Performance Steps (cont.)
d. Perform Vehicle Signals. Move to the left Move to the right Move forward Attention I am ready / ready to move. Mount Disregard previous command. I do not understand
21
Move to Left
22
Extend arm to the right and raise it up and down.
Move to Right Extend arm to the right and raise it up and down.
23
forearms backward and for- ward, palms toward the chest.
Move Forward Move the hands and forearms backward and for- ward, palms toward the chest.
24
Attention!! Extend the arm sideways, slightly above the horizontal; palm to the front; wave the arm to and from the head several times.
25
I Am Ready, or Ready to Move, Are you Ready?
26
Two or three movements up- ward with the open hand, palm uppermost.
MOUNT Two or three movements up- ward with the open hand, palm uppermost.
27
Disregard Previous Command or As You Were
Raise both arms and cross wrists above the head, palms to the front.
28
I Do Not Understand Extend both arms horizontally to the sides and then bend your arms at the elbow so that your hands move across your face, one above the other. Palms should face out.
29
Performance Steps (cont.)
d. Perform Vehicle Signals. (cont.) 9. Start engine / prepare to move 10. Halt / stop 11. Increase speed 12. Advance 13. Open up / close up 14. (make a) right or left turn 15. Slow down 16. Move in reverse
30
Start Engine, or Prepare to Move
DAY NIGHT Simulate cranking of the engines by moving the arm, with the fist, in a circular motion at waist level. Move a light to describe a horizontal figure 8 in a vertical plane in front of the body.
31
HALT or STOP Raise the hand upward to the full extent of the arm, palm to the front. Hold that position until the signal is understood. NIGHT DAY Move a light horizontally back and forth several times across the path of approaching traffic to stop vehicles. Use the same signal to stop engines.
32
Increase Speed DAY NIGHT
Move a light vertically several times in front of the body. DAY NIGHT Raise the fist to shoulder level; thrust the fist upward the full extent of the arm and back to shoulder level (rapidly) several times.
33
Advance or Move Out
34
OPEN UP Extend the arms overhead, palms inward, then slowly lower arms to a horizontal position.
35
CLOSE UP Extend both arms parallel to the ground, palms up, then move the arms upward and inward towards the head.
36
Right or Left Turn DAY NIGHT Extend the arm horizontally to side, palm outward. Rotate a light to describe a circle 12 to 18 inches in diameter in the direction of the turn.
37
Slow Down DAY Extend the arm horizontally sideward, palm to the front; wave the arm slightly downward several times. keeping the arm straight. Do not move arm above horizontal. NIGHT Hold a light at shoulder level; blink it several times toward the vehicle.
38
(For Stationary Vehicles)
Move in Reverse (For Stationary Vehicles) Hold a light at shoulder level; blink it several times toward the vehicle. DAY NIGHT Face the vehicle(s) being signaled, raise the hands to shoulder level, palms to the front. Move hands forward and backward.
39
Performance Steps (cont.)
d. Perform Vehicle Signals. (cont.) 17. Close distance between vehicles and stop 18. Stop engines 19. Dismount 20. Neutral steer 21. Stop 22. Button up / unbutton 23. Message Acknowledged
40
Close Distance Between Vehicles and Stop
Face the vehicle(s) being signaled. Extend the forearms to the front, palms in- ward and separated (width of the shoulders). Bring the palms together as the vehicle(s) approaches. The vehicle(s) must stop when the palms come together.
41
Stop Engines Extend the arm parallel to ground, hand open, and move the arm across the body, in a throat-cutting action.
42
Dismount Extend the arms, make two or three movements up and down, hands open towards ground.
43
Neutral Steer (Track Vehicles) Cross the wrists at the throat; point the index finger in the direction of steer. Make a fist ot the other hand.
44
STOP Clasp the hands together, palms facing, at chin level.
(Alternate signal to stop tracked vehicles) Clasp the hands together, palms facing, at chin level.
45
Button Up or Unbutton For BUTTON UP, place both hands, one on top of the other, palms down, on top of the helmet. The arms are back and in same plane as the body. For UNBUTTON, give BUTTON UP signal, then separate the hands, Moving them to each side in a slicing motion; repeat.
46
Message Acknowledged Hold the fist out with thumb up.
47
Performance Steps (cont.)
3. Perform Flag Signals Single signal flag Mount Dismount Dismount & Assault Assemble / Close Move Out Nuclear, Biological or Chemical Hazard Present.
48
Use a Single Signal Flag
*When alone, flag colors have these meaning. **In poor visibility, you can use colored chemical lights or flashlights with colored filters in place of flags.
49
MOUNT
50
Dismount
51
Dismount & Assault
52
Assemble or Close
53
Move Out
54
NBC Hazard Present
55
Performance Measures (cont.)
Note: When used alone flag colors have the following meaning: 1. Red-Danger or enemy in sight 2. Green-All clear, ready or understood 3. Yellow-Disregard or vehicle out of action
56
CHECK ON LEARNING
57
CHECK ON LEARNING
58
Performance Measures(cont.)
1. Executed proper formation signals. 2. Executed proper drill signals. 3. Executed proper movement technique signals. 4. Executed proper signals to control vehicle drivers and crews. 5. Executed proper flag signals. Evaluation Preparation: SETUP: At the test site, provide a set of vehicle-signaling flags and flashlight. From the signals shown in the task, pick 10 to test. BRIEF SOLDIER: Tell the Soldier you will give the ten signals, and he must correctly execute each one
59
QUESTIONS?
Similar presentations
© 2024 SlidePlayer.com. Inc.
All rights reserved.