1. 1 Muhammad Amir Yousaf Electrical Engineering BA (B), Analog Electronics, ET065G 6 Credits ET064G 7.5 Credits

2. Introduction Electronic Systems? What is Analog Electronics? Course Aims? Course contents? Revision of Prereqs. 2 Muhammad Amir Yousaf

3. Nature is Analog 3 Muhammad Amir Yousaf A variation in a natural process is always well defined and continuous in time.

4. Nature is Analog 4 Muhammad Amir Yousaf An electrical signal that is analogous to variation in natural phenomenon is ‘Analog Signal’ The term "analog" describes the proportional relationship between an original natural variation and an electrical that represents the phenomenon. Electronics

5. Electronics that reads Nature  Primary information from natural phenomena comes in the form of optical, acoustic, thermal or chemical signals.  These signals are converted into electrical signals. The devices used for such conversions are called transducers or sensors.  Electronics involved in conversion and handling of these signals is Analog Electronics A Light Dependent Resistor 5 Muhammad Amir Yousaf

6.  Electronics circuit design is an art of handling information carried in electrical signals.  The electrical signals obtained from the transducers could be very delicate and weak in strength and prone to noise and interference.  The obtained signals are than treated against the noise and amplified to strengthen them.  After this the electrical signals could be used to make certain decisions or converted back into the physical signal or quantities for display or actuation. Electronics circuit design : An art 6 Muhammad Amir Yousaf

7. A Light Sensitive lighting system Muhammad Amir Yousaf 7

8. Analog Electronics Systems  Block diagram of an analog electronic system. Non-electrical information Input Transducer Interface Processor/ Filter Interface Display / Digital End / Actuator A Loud Speaker system. 8 Muhammad Amir Yousaf

9. Typical block chain in an Electronic System  Sensor/Transducer: converts the real-world signal into an analog electrical signal.  Filters: The analog signal is often weak and noisy, so filters are required to remove noise.  Amplifiers: are needed to strengthen the signal.  A/D converters: if digital processing is required. 9 Muhammad Amir Yousaf

10. Typical block chain in an Electronic System  An analog-to-digital converter transforms the analog signal into a stream of 0‘s and 1's.  The digital data is processed by a CPU, such as a DSP, a microprocessor, or a microcontroller.  Digital-to-analog conversion (DAC) is necessary to convert the stream of 0's and 1's back into analog form. 10 Muhammad Amir Yousaf

11. Op-Amps in electronic system 11 Muhammad Amir Yousaf  An important building block used for amplification and filtering is : Operational Amplifier.

12. Course Plan  About the course:  The course gives a deeper understanding and knowledge in analog circuit design and covers analog amplifiers, noise, filters, stability, oscillators, power supplies. The theory will be verified both with simulations and measurements of analog electronics circuits.  Prerequisite:  Electrical Engineering BA (A): Circuit Theory and Electronics, BA (A), 7.5 Credits. 12 Muhammad Amir Yousaf

13. Course Plan  Prerequisites :  Electrical Engineering BA (A): Circuit Theory and Electronics, BA (A), 7.5 Credits.  Dc circuit analysis  Understanding of basic passive components  jw method for solving ac circuit equations ( Introductory Circuit Analysis Chapter 14)  Passive Filters  Op-amps: introduction 13 Muhammad Amir Yousaf

14. Course Plan  Course aim and goal  Students will gain a deeper understanding and knowledge of circuit design and characteristics.  Students will acquire skills in the design of the amplifiers, filters, oscillators and power supply etc.  Students will acquire proficiency in the use of computerized simulation tools. 14 Muhammad Amir Yousaf

15. Course Plan  Course Contents  The course covers:  System properties of analog circuits  Short refresher of basic elements: Circuit theory, Bode plots, Simple RC filters  Semiconductor Devices  Different OP-Amp circuits  Instrumentation amplifiers  Characteristics of different types of operational amplifiers  Frequency-dependent couplings  Feed-back of amplifiers  Stability  Noise and noise models for operational amplifiers  Various application examples 15 Muhammad Amir Yousaf

16. Required Literature  Thomas L. Floyd, "Electronic Devices - Conventional Current Version" Available from www.pearsoned.co.uk/student. Use ”voucher code” ZP038E för 20% extra discount. Delivery is with DHL and takes 5-6 days to Sweden. Also available from the internet bookstores. ISBN 9781292025643  Don Manchini, "Op Amps for Everyone" -Free downloadable pdfFree downloadable pdf  Course web-page: apachepersonal.miun.se/~amiyou/ 16 Muhammad Amir Yousaf Last Year Offer

17. Teachers  Muhammad Amir Yousaf S- Building 241-F 060148748 apachepersonal.miun.se/~amiyou/ 17 Muhammad Amir Yousaf

18. Lecture Plan (i)  Introduction to Course:  Course Plan  Aims and Goals  Course Contents.  Lecture 1: Revision of some basic concepts such as:  RC filters  Bode plots  Transfer function etc.  Lecture2: Discrete Semiconductor devices  Diodes (Diodes, LEDs, Zener)  Transistors (Bipolar and MOSFETs).  Literature:  Chapter 2 of text book ‘Electronic Devices’, Lecture notes 1 18 Muhammad Amir Yousaf

19. Lecture Plan (ii)  Lecture 3  Operational Amplifies  Ideal and Practical op-amps  Input Signal Modes (Differential and Common Mode)  Voltage Current Impedance  Frequency Response  Literature:  Lecture Notes 2  Electronic Devices : Chapter 12  Op-amp for every one. 19 Muhammad Amir Yousaf

20. Lecture Plan (iii)  Lecture 4-5  Inverting & Non Inverting amplifiers  Voltage follower  Parameters and Operational amplifier properties  Bias current and offset voltage  Feedback,  Open and closed loop response, Stability  Literature:  Lecture Notes 3  Electronic Devices : Chapter 12  Op-amp for every one. 20 Muhammad Amir Yousaf

21. Lecture Plan (iv)  Lecture 6-7  Comparator  Summing and averaging amplifier  Instrumentation amplifier  Integrator and Differentiator  Charge sensitive amplifier  Current to voltage amplifier  Instrumentation amplifier  Oscillators, Active filters  Peak Detector  Literature: Lecture Notes 4  Electronic Devices : Chapter 13, 14, 16  Op-amp for every one. Chapter 16 21 Muhammad Amir Yousaf

22. Lecture Plan (v)  Lecture 8  Noise  Noise Factor  Literature:  Lecture Notes 5  Op-amp for every one: Chapter 10  Lecture 9  Power Supply  Linear Supply, Switch mode supplies 22 Muhammad Amir Yousaf

23. Exercise Plan  Exercise 1:  Revision of Circuit Theory concepts  Bode Plots  Exercise 2  Exercise 3 23 Muhammad Amir Yousaf

24. Lab Plan  Lab 1: Basic Op amp circuits:  The most basic OP-Amp circuits should be connected and characterized.  Some fundamental non ideal properties of the OP-Amp will also be characterized.  Lab 2: Active Filters:  Active filters should be designed according to given specifications. You should consult with the book ‘op-amp for every one’  Lab3: Power Supply Design  Fun Lab 24 Muhammad Amir Yousaf

25. Examination and Grading System  A written exam for 4.5 hp will be held 31st October  The grades A, B, C, D, E, Fx and F are given on the course. On this scale the grades A through E represent pass levels, whereas Fx and F represent fail levels.  Labs 1.5 hp will be graded as Pass and Fail  Assignment 1.5hp with grades A to F (ET064G) 25 Muhammad Amir Yousaf

26. Part II Refresher Part I Muhammad Amir Yousaf 26

27. DC Circuit analysis  Circuit analysis is the process of finding the voltages across, and the currents through, every component in the circuit.  For dc circuits the components are resistive only and analysis is simpler.  Ohm Law,  Series, Parallel circuits,  Kirchhoff’s voltage and current laws,  Current, Voltage divider rules,  Thevenin, Norton’s theorems. Muhammad Amir Yousaf

28. DC and AC Circuit analysis  For dc circuits the components are resistive as the capacitor and inductor show their complete characteristics only with varying voltage or current.  One form of alternating waveform is sinusoidal waveform where the amplitude alternates periodically between two peaks.  Number of cycles per unit time is frequency. Muhammad Amir Yousaf

29. Sinusoidal Waveform  Unit of measurement for horizontal axis can be time, degrees or radians. Muhammad Amir Yousaf

30. Sinusoidal Waveform  Unit of measurement for horizontal axis can be time, degrees or radians. Muhammad Amir Yousaf Vertical projection of radius vector rotating in a uniform circular motion about a fixed point.  Angular Velocity  Time required to complete one revolution is T

31. Sinusoidal Waveform  Mathematically it is represented as: Muhammad Amir Yousaf

32. Frequency of Sinusoidal  Every signal can be described both in the time domain and the frequency domain.  Frequency representation of sinusoidal signal is: Muhammad Amir Yousaf

33. A periodic signal in frequency domain  Every signal can be described both in the time domain and the frequency domain.  A periodic signal is always a sine or cosine or the (weighted) sum of sines and cosines.  Frequency representation of periodic signal is: V f s 2 fs 3 fs 4 fs 5 fs f Muhammad Amir Yousaf

34. A periodic signal in frequency domain  A periodic signal (in the time domain) can in the frequency domain be represented by:  A peak at the fundamental frequency for the signal, f s =1/T  And multiples of the fundamental f 1,f 2,f 3,…=1 x f s,2 x f s,2 x f s V T=1/f s t V f s 2 fs 3 fs 4 fs 5 fs f Kent Bertilsson Muhammad Amir Yousaf

35. Non periodic signal in frequency domain  A non periodic (varying) signal time domain is spread in the frequency domain.  A completely random signal (white noise) have a uniform frequency spectra V Noise f Kent Bertilsson Muhammad Amir Yousaf

36. Why Frequency Representation?  All frequencies are not treated in same way by nature and man-made systems.  In a rainbow, different parts of light spectrum are bent differently as they pass through a drop of water or a prism.  An electronic component or system also gives frequency dependent response. Muhammad Amir Yousaf

37. Phase Relation  The maxima and the minima at pi/2,3pi/2 and 0,2pi can be shifted to some other angle. The expression in this case would be: Muhammad Amir Yousaf

38. Derivative of sinusoidal Muhammad Amir Yousaf

39. Response of R to Sinusoidal Voltage or Current  Resistor at a particular frequency Muhammad Amir Yousaf

40. Response of L to Sinusoidal Voltage or Current  Inductor at a particular frequency Muhammad Amir Yousaf

41. Response of C to Sinusoidal Voltage or Current  Capacitor at a particular frequency Muhammad Amir Yousaf

42. Frequency Response of R,L,C  How varying frequency affects the opposition offered by R,L and C Muhammad Amir Yousaf

43. References http://www.handbuiltpotteryonline.net/ https://picasaweb.google.com/107263748601915715835/NesargiKarmicPranjal#5556691209155746434 http://qtweb.ca/2012/08/20/setting-your-seo-goals/ http://www.istockphoto.com/stock-illustration-5738901-race-winner-finishing-line.php http://www.sodahead.com/fun/do-you-think-too-much-wisdom-is-a-powerful-thing-or-more-of-a-dangerous- thing/question- 1239041/?page=1&postId=41088893#post_41088893&link=ibaf&q=deep+understanding&imgurl=http://mindbodysmil e.com/wp-content/uploads/2009/01/dontknow.jpg http://thsc.com.sg/digital-hearing-aids-techs-signals.php http://www.whatcircuits.com/software/electronic-simulator-and-analysis/5spice/ http://www.cstr.ed.ac.uk/research/projects/inversion/ http://www.karbosguide.com/hardware/module7c1.htm 43 Muhammad Amir Yousaf