Download presentation
Presentation is loading. Please wait.
Published bySheena Hodges Modified over 9 years ago
1
LIFTER AND CAM LOBE u Lifter face has Convex Shape u Cam Lobe has taper of.0007” to.002” u Lifter must spin to Dissipate Load u Lifter’s convex shape prevents Edge Loading Page 193
2
LIFTER AND CAM LOBE u Cam and Lifters become wear mated in first few minutes u If cam is replaced replace lifters also u Used lifters will rapidly wear out a new cam
3
LIFTER AND CAM LOBE u Lubrication and Break-in u Cam is lubed by crank spray u First 1/2 Hour is Critical u Must use (EP) Extreme Pressure Lubricant
4
LIFTER AND CAM LOBE u Minumum RPM 1500 for 15 Minutes u Some OHV have oil passage in cam u Oil holes on each Lobe, if plugged instant cam failure. u Oil changes are importiant to cam life. Page 194 Figure 8.21
5
CAM LOBE SHAPE u Base circle u Lobe u Opening and Closing Flank u Opening and Closing Ramp Page 194 Figure 8.22
6
CAM LOBE SHAPE u Lift u Duration u Overlap Page 195
Similar presentations
© 2025 SlidePlayer.com. Inc.
All rights reserved.