1. Layers and perimeters

3. First Layer Height=.35 & Solid Layers Bottom=3 Layer Height Solid Layers Top=3 If Solid Layer Top=3 the top Three layers will be printed solid Based on the Infill:Top/Bottom Fill Pattern. In the image on the right The top/bottom pattern is Hilbertcurve. The Infill Layer is an inner fill (non – solid) Honeycomb layer. Perimeters Infill Layer

4. Perimeter = 2 Perimeter = 6 Infill:Fill Pattern=Honeycomb

5. Top layer fill patterns

6. Infill

7. Fill Density = 0.4 Fill Density = 0.1

8. Infill:Fill Pattern=Honeycomb Infill:Fill Pattern=Rectlinear

9. Solid every 20 th layer Layers Solid Layers Bottom=7

10. Fill Angle=45 Fill Angle=0

11. Top/bottom fill patterns concentric

12. Top/bottom fill patterns Hilbertcurve

13. Top/bottom fill patterns Rectlinear

14. Top/bottom fill patterns Archimediancords

15. Top/bottom fill patterns Octagramspiral

16. Skirt and Brim

18. Loops = 3 Distance 6mm Skirt Height = 5 Brim = 2.5mm

19. Support Material

21. Object Skirt Raft

22. Layer 1 – default fill Layer 2 –applied parameters Layer 2 applies the Pattern, rectlinear, at the pattern spacing and angle. This pattern will be repeated for the layer specified in by Raft Layers 2.5mm

23. 10mm Pattern spacing=4mm Five Interface layers { { 10 Raft Layers Pattern spacing change from 4 to 2.5

24. Object first solid layer