1. OSHA Region IV Electrical Outreach General Industry Photos 29 CFR 1910 Regulations

2. General Industry Photos Standard – 1910.254(d)(9)(iii) Description – Welding lead cable splice were not insulated. All splices and metal parts of cables and parts must be guarded.

4. General Industry Photos Standard – 1910.303(b)(1) Description – Building wiring systems were not properly installed. Wiring draped over building surfaces.

6. General Industry Photos Standard –1910.303(b)(2) Description – Equipment not installed IAW listing requirements.

8. General Industry Photos Standard – 1910.303(g)(1)(iii) Description – Access to circuit breaker panels blocked.

10. General Industry Photos Standard –1910.303(g)(2)(i) Description – Live parts exposed.

12. General Industry Photos Standard –1910.303(g)(2)(i) Description – The receptacle was not properly installed in the junction box which exposed energized parts.

14. General Industry Photos Standard – 1910.303(g)(2)(i) Description – Broken electrical receptacle exposing energized parts.

16. General Industry Photos Standard – 1910.303(g)(2)(i) Description – Live parts of 480 VAC electrical system exposed. All live parts are required to be guarded.

18. General Industry Photos Standard – 1910.303(g)(2)(i) Description – Front cover removed from circuit breaker panel. Live parts exposed.

20. General Industry Photos Standard – 1910.304(f)(5)(v) Description – Portable light with metal guard which is required to be grounded.

22. General Industry Photos Standard – 1910.304(f)(5)(v) Description – The ground pin was removed from the electric plug.

24. General Industry Photos Standard – 1910.305(a)(2)(iii)(G) Description – Electrical wiring was not protected from damage. Lying across road where cranes and other vehicular traffic could pass over the wiring.

26. General Industry Photos Standard –1910.305(b)(2) Description – The faceplate was removed from the receptacle exposing the energized parts.

28. General Industry Photos Standard – 1910.305(e)(1) Description – Electrical systems were not designed for wet and damp locations

30. General Industry Photos Standard –1910.305(g)(2)(iii) Description – The electrical plug did not have adequate strain relief which causes stress on the contacts.

32. General Industry Photos Standard – 1910.305(j)(1)(iv) Description – Electric cords and cables lying in water.

34. General Industry Photos Standard –1910.305(j)(1)(iv) Description – The receptacle which was approved for wet and damp locations was damaged.

36. General Industry Photos Standard – 1910.307(b)(1) Description – Electrical wiring was not approved for hazardous locations. Paint spray area.

38. General Industry Photos Description – Electrical wiring and systems were not installed IAW NEC.