1. 1 PREPARING C – SILICONES

2. 2 Easy processing Easy processing Easy dosage, short mixing time, easy check of Easy dosage, short mixing time, easy check of homogeneously mixed material with colour contrast catalyst homogeneously mixed material with colour contrast catalyst PREPARING SILOFLEX PLUS

3. 3 dosage PREPARING SILOFLEX PLUS PUTTY dose putty material using measuring spoon  dose putty material using measuring spoon  impress the edge of the spoon into the selected putty  2 strand-lengths of the catalyst (8 cm) per 1 spoon An excess amount of catalyst shortens the working and the setting times.

4. 4 PREPARING SILOFLEX PLUS PUTTY mixing !!! Work in protective gloves only !!! knead the substance thoroughly to achieve a homogeneous colour without pink stripes  knead the substance thoroughly to achieve a homogeneous colour without pink stripes 45 s

5. 5 Method of double impression PUTTY APPLICATION Method of double impression PUTTY APPLICATION Application on the tray Inserting into the mouth Outlet holes cutting Impression

6. 6 PUTTY

7. 7 dosage mixing 1:1 30 s PREPARING SILOFLEX PLUS LIGHT  mix until a homogeneous colour is achieved, spread thoroughly along the pad to achieve a smooth consistency without bubbles

8. 8 Applying Light to the tray Inserting and fixing in the mouth Method of double impression LIGHT APPLICATION Method of double impression LIGHT APPLICATION

9. 9 Method of double impression Method of double impression

10. 10  Impression - disinfection Disinfection in standard disinfection solution (e. g. Jodisol diluted with water at a ratio of1:10) Disinfection in standard disinfection solution (e. g. Jodisol diluted with water at a ratio of1:10)  Store the impression at room temperature (up to 25 ºC)  Plaster can be placed in the impression 30 minutes from removal of the impression from the mouth  There are no time limitations, but it is recommended to cast within 4 hours. IMPRESSION - PROCESSING

11. 11 PREPARING SILOFLEX PLUS Mistakes in preparation  non-homogeneous mixing – it can cause a foliated impression  Too quick setting, resp. no setting due to mixing ratio  Bad reproduction – impression at the end of working time

12. 12 Thank you for your attention!