1. MET 141 Manufacturing Processes and Materials Change of Form Spring 2002

2. Introduction Other forms of manufacturing involve methods that reduce or increase the volume of a material. When changing the form of a workpiece, we are only changing the shape. Major methods include: Melting the material Powdering the material Deforming the material These processes include many methods of: Casting Materials Powder metallurgy Forging Bending Drawing Spin forming High-energy forming

3. Casting Involves placing a liquid material into a mold where it hardens or solidifies into a final shape. Variations of casting include: Sand Casting Green Sand Dry Sand Investment processes Lost wax Shell mold Centrifuged Slush Continuous Permanent Mold Processes Gravity feed Low-pressure feed Hot-chamber Die Cold-chamber Die Centrifugal

4. Basic Concept Many terms used in sand casting apply to other forms of casting. Basic concept of sand casting is that fine sand is packed around a pattern to form a mold. Pattern is then removed leaving a cavity. Molten metal, ceramic slurry, or other liquefied material is poured in. Once solidified, the mold is opened and the work piece is removed.

5. Patterns In sand casting, patterns are generally made out of a hardwood. Since most metals shrink when they cool the pattern must be made oversized. Shrinkage of steel castings vary from 0.5% to 2% depending on the alloy in the steel

6. Two Significant Problems Two significant problems. Parting plane through the longest horizontal section Draft angle-typically about 2 degrees

7. Sand Casting Procedure Only damp sand will work. Oil or water is mixed into sand (mulling) Sand is packed into a flask around a pattern 2 parts: upper (cope), lower (drag) Vertical hole (sprue) is cut in which to pour liquefied material. Horizontal holes (runners) are cut from sprue to pattern. Pattern is removed and two halves are mated together.

8. Sand Casting Procedure Dam is created to allow molten metal to flow into sprue under oxide layer. Gate controls and allows even horizontal flow of material into the mold (good grain structure) Trap catches loose sand Vents allow steam or trapped gas to escape.

9. Sand Casting Procedure cont. Riser allows molten material to completely fill the mold. Metal is poured slowly and evenly until seen in the riser. Metal solidifies. Most metals shrink on the surface. Sprue and riser is cut from the part.

10. Casting Assembly Line

11. Multiple Casts Single sprue tree Multiple runners and patterns

12. Characteristics AdvantagesDisadvantages Sand Casting (Green Sand)

13. Characteristics AdvantagesDisadvantages Sand Casting (Dry Sand)

14. Characteristics AdvantagesDisadvantages Investment Casting (Lost Wax)

15. Characteristics AdvantagesDisadvantages Investment Casting (Shell Mold)

16. Characteristics AdvantagesDisadvantages Investment Casting (Centrifuged)

17. Characteristics AdvantagesDisadvantages Investment Casting (Vacuum)

18. Investment Casting (Vacuum)

19. Characteristics AdvantagesDisadvantages Permanent Mold (Gravity Feed)

20. Characteristics AdvantagesDisadvantages Permanent Mold (Low Pressure Feed)

21. Characteristics AdvantagesDisadvantages Permanent Mold (Hot Chamber Die)

22. Characteristics AdvantagesDisadvantages Permanent Mold (Cold Chamber Die)

23. Characteristics AdvantagesDisadvantages Permanent Mold (Centrifugal)

24. Permanent Mold (Centrifugal)

25. Characteristics AdvantagesDisadvantages Permanent Mold (Slush)

26. Characteristics AdvantagesDisadvantages Permanent Mold (Continuous Pour)

27. Casting Based on Weight

28. Casting Based on Material

29. Characteristics AdvantagesDisadvantages Investment Casting (Lost Wax)

30. Casting Based on Shape