1. Bottom insulation plate
4/15/2017
Top insulation plate
Top plate
Hot nozzle
Hot runner plate
A plate
Cavity insert
Core insert
Slider
Lifting device
B plate
Support pillar
Ejector pin
Support plate
Ejector plate
Ejector return plate
Lifter
Bottom plate
Bottom insulation plate

4. Hydraulic cylinder
Hydraulic cylinder

5. ※Because the big slider construct is very complex, so the slider moving must slow by the hydraulic cylinder, otherwise the slider will be damaged easy.
因为结构复杂，大行位在油缸推动的过程中速度一定要慢,否则行位容易损坏.

6. ※The base of big slider is closed and the yellow inner slider is open before close the mold like the bottom picture show , because the yellow inner slider close by the angle pin of cavity, before the first of close the mold you must insure the big slider at such state.
合模前大行位座必须在关闭的位置，黄色内行位必须是打开的状态如下图所示,因为黄色行位需要通过前模斜导柱闭合, 首次合模前必须确保大行位处于这样的状态.
Angle pins
斜导柱

8. Safety device
Topinsulation plate
Top plate
Hot nozzle
Hot runner plate
A plate
Cavity insert
Slider
Core insert
Lifting device
B plate
Space block
Ejector pin
Support pillar
Eject plate
Lifter
Eject return plate
Bottom plate
Bottom insulation plate

9. Safety device
Cavity insert
Wedge
Adjusting plate

10. Slider Hydraulic cylinder Adjusting plate Press block Core insert