Download presentation
Presentation is loading. Please wait.
Published byDavid Chandler Modified over 9 years ago
1
Chapter 12: Circuit Switching and Packet Switching Business Data Communications, 6e
2
2 Switching Techniques Data transmitted through a network of intermediate switching nodes, which are not concerned with content End devices receiving data are stations; switching devices are nodes A collection of nodes is a communication network A switched communication network routes data from one station to another through nodes
3
Simple Switching Network 3
4
4 Switched Network Characteristics Some nodes connect only to other nodes for switching of data; other nodes have one or more stations attached as well. Node-station links are generally dedicated point- to-point links; ode-node links are usually multiplexed links Usually, the network is not fully connected; however, it is desirable to have more than one possible path through the network for each pair of stations to enhance reliability
5
Circuit-Switching Networks Dominant technology for voice technology Synchronous communication – requires a dedicated path –Involves 3 phases -Circuit establishment -Data transfer -point-to-point from endpoints to node -internal switching/multiplexing among nodes - Circuit disconnect 5
6
6 Circuit Establishment Station requests connection from node Node determines best route, sends message to next link Each subsequent node continues the establishment of a path Once nodes have established connection, test message is sent to determine if receiver is ready/able to accept message
7
7 Data Transfer Point-to-point transfer from source to node Internal switching and multiplexed transfer from node to node Point-to-point transfer from node to receiver Usually a full-duplex connection throughout
8
8 Circuit Disconnect When transfer is complete, one station initiates termination Signals must be propagated to all nodes used in transit in order to free up resources
9
9 Circuit Switching Characteristics Channel capacity is dedicated for the duration of a connection, even if no data are being transferred Once the circuit is established, the network is effectively transparent to the users, resulting in negligible delays Developed to handle voice traffic but is now also used for data traffic
10
10 Circuit Switching Applications Public Telephone Network (PSTN) Private Branch Exchanges (PBX) Private Wide Area Networks (often used to interconnect PBXs in a single organization) Data Switch
11
11 Public Switched Telephone Network (PSTN) Subscribers Subscriber Line (“local loop”) –Connects subscriber to local telco exchange Exchanges (“end office”) –Telco switching centers –>19,000 in US Trunks –Connections between exchanges –Carry multiple voice circuits using FDM or synchronous TDM –Managed by IXCs (inter-exchange carriers)
12
Circuit Establishment 12
13
13 Control Signaling Manage the establishment, maintenance, and termination of signal paths Includes signaling from subscriber to network, and signals within network For a large public telecommunications network, a relatively complex control signaling scheme is required
14
14 Signaling Functions Audible communication with the subscriber Transmission of the number dialed Information between switches that a call cannot be completed Information between switches that a call has ended and the path can be disconnected Telephone ring signal Transmission of billing information Transmission of equipment and trunk status information Transmission of system failure diagnostic information Control of special equipment (e.g. satellite channel equipment)
15
15 Types of Control Signals Supervisory Address Call Information Network Management
16
16 Supervisory Signals Binary character (true/false; on/off) Deal with the availability of the called subscriber and of the needed network resources Used to determine if a needed resource is available and, if so, to seize it. Also used to communicate the status of requested resources.
17
17 Address Signals Identify a subscriber Initially generated by a calling subscriber when dialing a telephone number Resulting address may be propagated through the network to support the routing function and to locate and ring the called subscriber's phone
18
18 Call Information Signals Provide information to the subscriber about the status of a call In contrast to internal signals (which are analog or digital electrical messages), these are audible tones that can be heard by the caller or an operator with the proper phone set
19
19 Network Management Signals Used for the maintenance, troubleshooting, and overall operation of the network These signals cover a broad scope, and it is this category that will expand most with the increasing complexity of switched networks
20
20 In-Channel Signaling Traditionally, control signals were carried on the same channel as the call to which the control signals relate Drawbacks –Information transfer rate limited –Delay between entering a number and establishing a connection
21
Business Data Communications, 5e21 Common-Channel Signaling Control signals are carried over paths completely independent of the voice channels One independent control signal path can carry the signals for a number of subscriber channels (i.e. is a “common control channel” for these channels)
22
22 Softswitch Architecture A general-purpose computer running specialized software that turns it into a smart phone switch Cost significantly less and can provide more functionality Can convert digitized voice bits into packets, opening transmission options (e.g. voice over IP) Physical switching function: media gateway (MG) Call processing logic: media gateway controller (MGC)
23
PBX Components Control Processor: runs the software that operates system features. Modules: House interface cards that provide endpoint interfaces to the switch. Inter-module switching: allows the interconnection of ports in diffreent modules, using circuit switching. 23
24
24 Softswitch Architecture Traditional and IP PBX
25
25 Packet-Switching Networks Developed in 1970s for long-distance data transmission due to circuit switching limitations –In user/host data connection the line is often idle, so circuit-switching is inefficient –Circuit-switching requires both devices to transmit and receive at the same data rate, limiting interconnection options
26
26 Packet Switching Operation Data is broken into packets, each of which can be routed separately Advantages: better line efficiency, signals can always be routed, prioritization option Disadvantages: transmission delay in nodes, variable delays can cause jitter, extra overhead for packet addresses
27
27 Packet Switching Illustration
28
28 Packet-Switching Techniques Datagram –each packet treated independently and referred to as a datagram –packets may take different routes, arrive out of sequence Virtual Circuit –preplanned route established for all packets –similar to circuit switching, but the circuit is not dedicated
29
29 Packet-Switched Routing Adaptive routing changes based on network conditions Factors influencing routing are failure and congestion Nodes must exchange information on network status Tradeoff between quality and amount of overhead
30
30 Packet-Switched Congestion Control When line utilization is >80%, queue length grows too quickly Congestion control limits queue length to avoid througput problems Status information exchanged among nodes Control signals regulate data flow using interface protocols (usually X.25)
31
31 WANs for Voice Requires very small and nonvariable delays for natural conversation--difficult to provide this with packet-switching As a result, the preferred method for voice transmission is circuit-switching Most businesses use public telephone networks, but some have implemented private voice networks VoIP uses packet transmission over Internets and intranets; it is enjoying gradually growing acceptance as an alternative
32
32 WANs for Data Public packet-switched networks Private packet-switched networks Private leased lines Public circuit-switched networks Private circuit-switched networks (interconnected digital PBXs) ISDN (integrate packet and circuit switching)
33
33 WAN Considerations Nature of traffic –stream generally works best with dedicated circuits –bursty better suited to packet-switching Strategic and growth control--limited with public networks Reliability--greater with packet-switching Security--greater with private networks
34
Wide Area Network Features 34 Feature Dedicated (Leased Lines) Public PacketPrivate Packet Strategic Control Network design, service, and maintenance can be given priority and controlled by user. Service limited to that which suits average customer. Network design, service, and maintenance can be given priority and controlled by user. Growth control and operation control Not integrated; decentralized fault detection may be expensive. Provided by service supplier to satisfy average requirements. Integrated into all equipment; centralized fault isolation and detection. Reliability Manual and user- visible recovery from failure. Transparent and automatic recovery from failure. SecurityPrivate users only.Public users, network access control. Private users only, network access control.
Similar presentations
© 2024 SlidePlayer.com. Inc.
All rights reserved.