2. CHAPTER 3 INTERNAL COMBUSTION ENGINES
Again, the study reference is CHAPMAN’S and the AUXILIARY study guide.

3. INTERNAL COMBUSTION ENGINES
DEFINITION: BOTH DIESEL AND GAS; CHANGE OR CONVERT HEAT ENERGY INTO WORK BY BURNING FUEL IN A CLOSED COMBUSTION CHAMBER. THE PISTONS USE AN UP-AND-DOWN MOTION. THUS, THEY ARE CLASSIFIED AS “RECIPROCATING” ENGINES.

4. IGNITION PRINCIPLES GASOLINE ENGINES
Uses SPARK IGNITION SYSTEM”
Called a “SPARK IGNITION ENGINE”.
Fuel and air mixed in a carburetor – ( Injection chamber if fuel injected).
Fuel drawn into cylinders.
Fuel/air mixture ignited by electric spark from sparkplug(s).

5. IGNITION PRINCIPLES DIESEL ENGINES
Engine takes atmospheric air and compresses it in cylinder head.
Injects fuel into combustion space ( cylinder head)
Fuel injectors. NO carburetors
Require extremely CLEAN fuel to properly ignite
Compression heating ignites fuel
NO SPARK PLUGS

6. OPERATING CYCLE
All reciprocating engines have definite operating cycle
Either 2-Stroke or 4-Stroke
STROKE: Up or Down movement of piston
Each PISTON completes 2 strokes for each revolution of the crankshaft.

7. OPERATING CYCLE FOUR STROKE (CYCLE)
SLIDE NO. 5
OPERATING CYCLE FOUR STROKE (CYCLE)
Each piston goes through 4-strokes
Crankshaft has 2 revolutions / one cycle
One power stroke per 2 revolutions of crank shaft

8. THE OPERATING CYCLE 4-STROKES
INTAKE
COMPRESSION
POWER
EXHAUST

9. OPERATING CYCLE INTAKE STROKE
Intake valve open.
Exhaust valve closed.
PISTON: Moving DOWN.
FUEL/AIR MIXTURE: Drawn IN through intake valve.

10. OPERATING CYCLE COMPRESSION STROKE
Both INTAKE and EXHAUST valves CLOSED.
PISTON moving UP.
Fuel/air mixture is COMPRESSED.
Ignition Spark and Compression heating ignites mixture.

11. OPERATING CYCLE POWER STROKE
INTAKE and EXHAUST valves are CLOSED
PISTON moving DOWN
CRANKSHAFT TURNS.
POWER stroke only time power is translated to crankshaft.

12. OPERATING CYCLE EXHAUST STROKE
EXHAUST valve OPEN
INTAKE valve CLOSED
PISTON moving UP
THIS ENDS THE 4-STROKE CYCLE
The piston immediately starts down again and the cycle process starts over.

13. OPERATING CYCLE TWO STROKE
DIESEL ENGINES ARE MOSTLY TWO STROKE
GASOLINE ENGINES MOSTLY LIMITED TO OUTBOARDS
HAS ONE COMPRESSION AND ONE POWER STROKE

14. OPERATING CYCLE TWO STROKE (DIESEL)
ONE power stroke for each revolution of the crankshaft
TWICE as many power strokes as in the four-stroke engine.
Cylinder has exhaust valve but NO INTAKE VALVE.
Air comes in through PORTS in cylinder wall
2-STROKE DIESELS GIVE EXCELLENT SERVICE

15. FUEL INJECTION SYSTEMS UNIT INJECTOR and COMMON RAIL
UNIT INJECTOR: Cylinder and plunger in cylinder head, sprays or squirts fuel into combustion chamber, for ignition. Fuel is INDUCTED from fuel tank to fuel injectors under pressure from a pump.
COMMON RAIL: Most commonly used. One pump for all cylinders. Fuel under pressure from tank to cylinder.
DRAWBACKS: System must be purged of all air until only fuel comes out. Time consuming, awkward and messy.

16. CARBURETOR
A device used to send a fine spray of fuel into a moving stream of air through the intake valves into the combustion chamber in the cylinder head of the engine.
On gasoline engines, used to control the fuel/air mixture.

17. OPERATING CYCLE COMPRESSION RATIOS
With compression ratio in diesel of 14:1, cylinder head temperature ~ 1000ºF. This heat ignites the fuel mixture without the spark plug ignition.
Diesel compression ration are close to 14: 1 to 16: 1
Gas compression ratios are close to 4: 1` to 8: 1

18. Includes the CYLINDERS, PISTONS, CONNECTING RODS AND CRANKSHAFT
POWER SYSTEM
Includes the CYLINDERS, PISTONS, CONNECTING RODS AND CRANKSHAFT

19. POWER SYSTEM CYLINDERS – PISTONS - CRANKSHAFTS
PISTONS: Move up and down in the cylinder; attached to the crankshaft and transmits power to the crankshaft .
CYLINDERS: Cast in a single engine block with a hardened sleeve alloy sleeve to reduce wear.
CRANKSHAFT: Changes the reciprocating motion of the piston and rods into rotary motion of the crankshaft which turns the propeller.

20. POWER SYSTEM VALVE and CAMSHAFT
VALVES: Opened by a CAMSHAFT which is driven by a CRANKSHAFT.
Let fresh air in. Allow combustion gasses to vacate.
CAMSHAFT: Changes rotary to intermittent reciprocating motion.

21. POWER SYSTEM AIR 4-STROKE (Cycle): Air enters INTAKE VALVE.
2-Stroke (Cycle): Air enters PORTS in cylinder wall.

22. POWER SYSTEM LUBRICATION
VITAL TO THE HEALTH OF THE ENGINE
Delivers oil to moving parts to assist in engine cooling and reducing friction.
Uses a PUMP and FILTER to cleanse and deliver

23. COOLING SYSTEM WATER and AIR
WATER: Holding tank, circulating pump and radiator to get rid of the heat in the water.
Both SEA and FRESH water are used.
FRESH water used with self-contained system.
SEA water straight from the environment.

24. ELECTRICAL SYSTEMS
GENERATOR/ALTERNATOR: Produces the electrical current to operate the vessel’s system and charge the battery.
VOLTAGE REGULATOR: Controls the voltage from the generator/alternator
CUT OUT: Keeps the battery from discharging through the alternator/generator at low speeds.
STARTER: An electric motor. Diesel may have separate starter motor.
Battery: Diesels require TWICE the power of gas engines.
Wiring harness: Carries the electrical current.

25. IGNITION SYSTEM(S) Ignition COIL Mechanical Breaker Condenser
Distributor
Spark Plug(s)
Switch
Wiring

26. IGNITION SYSTEM COMPONENTS
IGNITION COIL: The generated power source (FOR THE SPARK IN THE SPARK PLUG)
MECHANICAL BREAKER(POINTS): Break the current at proper time
CONDENSER: Prevents “arcing” when the points are open.
DISTRIBUTOR: Serves as a “selector switch” to distribute the current to the individual spark plugs (gas engine only)
SPARK PLUG(S): ( Gasoline engines only)Provided the “fire” to ignite the fuel in the combustion chamber. (Spark comes from the COIL, NOT the battery)

27. PRIMARY IGNITION CIRCUIT (LOW VOLTAGE) GASOLINE ENGINE
Battery
Ignition switch
Ignition coil (Low side)
Breaker points ( in distributor)
condenser

28. SECONDARY IGNITION CIRCUIT (HIGH VOLTAGE) GASOLINE ENGINE
DISTRIBUTOR (ROTOR)
IGNITION COIL (HIGH SIDE)
SPARK PLUGS

29. TROUBLE SHOOTING GAS ENGINES REQUIRE: 1. CORRECT FUEL-AIR MIXTURE
2. GOOD COMPRESSION
3. GOOD SPARK
DIESEL ENGINES REQUIRE:
1. CORRECT FUEL PRESSURE
2. HIGH COMPRESSION
3. NO AIR IN FUEL LINE(S)

30. REVIEW QUESTIONS NO.1
All reciprocating engines have a definite cycle of operation and __________________
operate on either a 2-stroke or 4-stroke cycle.
the number of cycles depends on the number of cylinders.
the 2-stroke cycle is used only in diesel engines since 4-stroke cycle is required for proper function of a gasoline engine.
the number of valves used for exhaust determine the operating cycle.

31. REVIEW QUESTIONS
All reciprocating engines have a definite cycle of operation and ________________
a. operate on either a 2-stroke or 4-stroke cycle.

32. REVIEW QUESTIONS NO. 2 2. The cam shaft_____________________
a. drives the propeller.
b. carries cams that are usually square in shape.
c. is used to rotate the cams that open the valves.
d. changes reciprocating motion to rotary motion .

33. REVIEW QUESTIONS 2. The cam shaft ______________________
c. is used to rotate the cams that open the valves.

34. REVIEW QUESTIONS NO. 3
3. Diesel engines have high compression ratios, in the range of 16:1 to 20:1, in order to_________
a. easily exhaust heavy diesel fuel.
b. provide maximum power in the intake stroke.
c. compress air to generate heat for fuel ignition.
d. assist the entrance of fuel from the carburetor.

35. REVIEW QUESTIONS
3. Diesel engines have high compression ratios, in the range of 16:1 to 20:1 in order to______________
c. compress air to generate heat for fuel ignition

36. REVIEW QUESTIONS NO. 4 4. A 2-stroke engine______________
a. has a compression and a power stroke.
b. is only used in diesel engines
c. has twice the power in very large gasoline engines
d. is so designated because there is a cycle of 2-strokes between the opening and closing of the exhaust valves
of each cylinder.

37. REVIEW QUESTIONS 4. A 2-stroke engine________________
a. has a compression and a power stroke.

38. REVIEW QUESTIONS NO. 5 5. In a diesel engine, fuel__________________
a. is injected directly into the cylinder or combustion chamber
b. is mixed with air, then injected into the cylinder
c. is also used for lubrication
d. consumption is constant at all speeds

39. REVIW QUESTIONS 5. In a diesel engine, fuel ________________
a. is injected directly into the cylinder or combustion chamber.

40. REVIEW QUESTIONS NO. 6
6. In a gasoline engine the fuel-air mixture ratio is controlled by the _________
a. throttle
b. carburetor
c. intake valve
d. fuel pump

41. REVIEW QUESTIONS
6. In a gasoline engine the fuel-air mixture ratio is controlled by the ____________________
b. carburetor

42. REVIEW QUESTIONS NO. 7 7. Lubricating oil in engines_______
a. is used for ignition and for friction reduction
b. is used only to lubricate the bearings and bushings
c. is always under constant pressure
d. is used to reduce friction and increase cooling.

43. REVIEW QUESTIONS 7. Lubricating oil in engines ______________
d. is used to reduce friction and increase cooling

44. REVIEW QUESTIONS NO. 8
8. Which of the following groups of items are common to both diesel and 4-cycle gasoline engines?
a. valves, carburetor and fuel pumps
b. valves, pistons and spark plugs
c. valves, cylinders and fuel pumps
d. valves, distributor and carburetor

45. REVIEW QUESTIONS
8. Which of the following groups of items are common to both the diesel and 4-cycle gasoline engine?
c. valves, cylinders and fuel pump

46. REVIEW QUESTIONS NO. 9
9. The primary circuit of the ignition system for gasoline engines includes the ________
a. distributor and breaker points
b. battery and spark plugs
c. ignition coil and breaker points
d. ignition coil and distributor

47. REVIEW QUESTIONS
9. The primary circuit of the ignition system for gasoline engines includes the _____________
c. ignition coil and breaker points

48. REVIEW QUESTIONS NO. 10
10. The high voltage that produces the spark in the spark plug in a gasoline engine is produced in the _____________________
a. battery
b. condenser
c. breaker points
d. ignition coil

49. REVIEW QUESTIONS
10. The high voltage that produces the spark in spark plug in a gasoline engine is produced in the ___________________
d. ignition coil

50. END CHAPTER 3