Presentation is loading. Please wait.

Presentation is loading. Please wait.

Guitar Neck Duplicator By Eric Hall. Problem To design a device that fabricates a rough (not sanded) guitar neck out of a stock piece of wood by following.

Similar presentations


Presentation on theme: "Guitar Neck Duplicator By Eric Hall. Problem To design a device that fabricates a rough (not sanded) guitar neck out of a stock piece of wood by following."— Presentation transcript:

1 Guitar Neck Duplicator By Eric Hall

2 Problem To design a device that fabricates a rough (not sanded) guitar neck out of a stock piece of wood by following a finished guitar neck.

3 What’s Available Expensive ($2,000 – $4,000) Manually Operated

4 Solution Autonomous Less expensive than what’s already available

5 Basic Design Driven by two stepper motors Adjustable sensors to accommodate different sized necks Uses commercially available router and bits Micro-controlled closed-loop system monitors and controls operation

6 Budget Stepper Motors$50.00 Aluminum$50.00 Spring$3.00 Sensors$10.00 Microcontroller$2.00 RouterSupplied Router Bit$25.00 Misc. Hardware$40.00 Total Cost$180.00

7 Timeline  The project length from brainstorming to completion will take approximately 5 months.


Download ppt "Guitar Neck Duplicator By Eric Hall. Problem To design a device that fabricates a rough (not sanded) guitar neck out of a stock piece of wood by following."

Similar presentations


Ads by Google