Download presentation
Presentation is loading. Please wait.
Published byAndrew Warren Modified over 9 years ago
1
Visit us at www.mcscontrols.com MCS-Connect
2
l Windows® based (95 thru 7) l Software written in Java l Grid size dynamic and updated in place l Updated typically every 2 to 3 seconds l Status, Trending/Graphs, Schedules l Transmit / Receive Configurator about 60 seconds uMCS-CONNECT General Information
3
l RS232 connection @ 19,200 baud l Local Ethernet @ 100 Mbps l Built in Gateway on each MAGNUM l Transmit Software (Both.hex &.cfg) l Expanded Graphing l Edit Date / Time Information uMCS-CONNECT General Information
4
Setup Windows & Modem Timers Remote/Dialup & IP uMCS-CONNECT OPENING SCREEN Local Serial/Ethernet
5
u SETUP COMMUNICATIONS Local & Remote Com Ports Modem Commands S8=4 Timing Functions Buffer Sizes Communications Speeds
6
u Phone Number Selection Use Scroll Bar to Find Site Drop down list of site names will appear. Use scroll bar to locate correct name or type name. When name is found click on it.
7
u Phone Directory After Selecting Dialup & Site Select ‘Remote/Connect’ to Dial System
8
u Local or Remote Site By MCS Address Hardware Serial # Configurator Name Manufacturer Model Name Unit Serial # Install Date Software Version # Get Authorized Config Version Config Date
9
u Authorization Select ‘Authorization’ Type 4 digit Auth # (0 thru 9) and Press ENTER on PC
10
u Overall Status Analog Outputs Relay Outputs Notification Control Status Sensor Inputs Select Info
11
u Relay Output Status Value / Manual Status Relay Output Name Last on / off Updated top of min Run Today /Yesterday Cycles Today /Yesterday Scroll to Right & Get Total Run Hrs & Total Cycles
12
u Relay Output Status Click on Name to highlight line Every Other Line Color Alternates Drop Down Relay Output Auto, Manual, Lockout
13
u Sensor Input Status Last on/off or Min/Max Sensor Type Offset Value Manual/Auto Status Current Value Sensor input Name
14
u Sensor Input Status Drop Down to Put Sensor in ‘AUTO or MANUAL’ Set CHIL OUT Manual
15
u Put Sensor in Manual Select Sensor Name Put in Sensor Manual Value
16
u Sensor Input Status Sensor input Name Run/Cycles or Min/Max Today Sensor input Value Sensor Manual Status Sensor Offset & Type
17
u Control Status Unit status Circuit Status Temp, Superht Status LLS/EXV status Select ‘Status, Alarms, SetPoints, Reset/Clear, Schedule & Service
18
u Alarms Select from tabs Last 100 Alarms
19
u Setpoints Target ± Ctl Zone EXV Set Points Liquid Inj. On Time ROC EXV
20
u Setpoints Capacity Ctl Load Pulse Ctrl Condenser Ctrl Slide Capacity Ctl
21
u Setpoints Condenser Ctrl Amp Ctrl Low Suct PSI Ctrl Compressor Ctrl
22
u Setpoints High Disc Psi Ctrl Comp Safety Ctrl Freeze & EXV Ctrl High Disc Tmp Ctrl
23
u Setpoints Target Target Adjusted with Reset Value Set Point Range Enter New Value
24
u Graph
25
u Graph Setup Relay Outputs Selected Sensor Inputs Selected Sample Interval Analog Outputs Selected Grid Control
26
l Access MCS-Connect Program l Check Communications Settings l Review Remote Phone List Hands On Time l Local Connection to a Demo Unit
Similar presentations
© 2025 SlidePlayer.com. Inc.
All rights reserved.