1. Boiler Demonstration in T800 Eurotherm a bc 3-Element Level Control To initiate the 3-element level control, enter a level Setpoint (between 0.5 & 4.5 metres). Press the centre of the drum to access information about 3-element level control. Press the button to close the pop-up window.

2. Boiler Demonstration in T800 Eurotherm a bc 3-Element Level Control When the feedforward (Steam Flow) is disabled, the controller enters the 2- element level control state (Master/Slave PID loops). Disabling the Feedwater Flow loop causes the controller to enter the single- element level control (single PID loop). The Feedwater Flow Setpoint is now unavailable to the operator.

3. Boiler Demonstration in T800 Eurotherm a bc Combustion Control Select the Cross-Limiting Combustion Control display. Operator/Engineer constants are displayed at the top (Fuel’s CV, Stoichiometric Air and Excess Air Requirement). The Pressure input allows you to set a Heat Demand for the Combustion Control. Press the top of the Air faceplate to access a trend pop-up for that PID loop. You can let the pop-up timeout or you can close it by pressing the button. Press the top of the Fuel faceplate to access the point pop-up page for the Fuel PID loop.

4. Boiler Demonstration in T800 Eurotherm a bc Trending Press the menu button and select Overview. This will take you to the Area display. Press any of the two groups to access the corresponding Group display. Using the scroll down button allows the display of the various trending displays for that particular group.