1. Physical changes
Brainstorm states of matter:

2. Energy Movement During Phase Change (absorbed or released)
States of Matter
Phase Change
Name
Energy Movement During Phase Change
Energy
IN or Out
(absorbed or released)

3. TEMPERATURE
The measure of the average energy of motion of the particles in a substance is

4. Changes in state are physical changes
Image source:

5. PHYSICAL CHANGE
A change that alters the form or appearance of a material but
does not convert the material into new substances.

6. Transformation of Water (H2O)

7. Graph showing changes in temperature over time:
Key Questions:
How does the graph show the transformation of water?
Describe the transformations that took place.
Describe what was happening at the particle level.
Make improvements in your graph. Show the following:
Diagram of particles at different
stages/phases.
Label processes such as melting,
condensing, boiling, evaporating
(Refer to your photos)
c. Graph of volume of water over time
Organize your photos to create a short video-journal of the transformation of Water.

9. Temperature (degrees Celsius)
Time-Temperature Graph for Water
100
Temperature (degrees Celsius)
Time (minutes)

12. Phase Diagram of Water

13. Time- Temperature Graph for Water
When will the temperature of the water rise above 100 degrees Celsius?
100
Temperature (degrees Celsius)
Why is the slope of the graph flat (no temperature change) at 100 degrees even though the stove is still on?
Why did temperature increase at a constant rate?
What is true for the ice-water mixture when the temperature began to rise?
Time (minutes)
Why is the slope of the graph flat (no temperature change) at 0 degrees?

14. Temperature –Time Graph for heating water
Why is the slope of the graph flat (no temperature change) at 0 degrees and 100 degrees even though the stove is still on?
What is true for the ice-water mixture when the temperature began to rise?
Why did temperature increase at a constant rate?
When will the temperature of the water rise above 100 degrees Celsius?

15. Temperature –Time Graph for heating water
Why is the slope of the graph flat (no temperature change) at 0 degrees and 100 degrees even though the stove is still on?
What is true for the ice-water mixture when the temperature began to rise?
Why did temperature increase at a constant rate?
When will the temperature of the water rise above 100 degrees Celsius?
energy from stove = energy required for phase change. No temperature change
No ice remains- only water for temp to increase
Constant stove temp, constant amount of water
When only water vapor remains- one state of matter

16. Temperature (degrees Celsius)
Time- Temperature Graph for Water
Once the water is in the gas phase, additional heat input raises the temperature of the water vapor Note: greater energy is needed to vaporize water than to melt it. WHY?
100
As the liquid begins to boil. Additional input of heat energy does not raise the temperature of the water, rather it is used to break water bonds. i.e. phase change.
Temperature (degrees Celsius)
As the temp approaches boiling point, the KE of the molecules is sufficient to allow the separation of molecules into the gas phase.
Once the water is in a liquid phase, increasing the amount of heat input raises the temp of the liquid water.
As the ice begins to melt, additional heat energy does not raise the temperature of the water, but loosens the bonds changing ice to water. i.e. phase change – melting.
Time (minutes)
As the temp approaches melting point temperature, the KE of the water molecules increases loosening the bonds between water molecules.

18. Copy Red and Blue-colored text
Page 49
Copy Red and Blue-colored text
Phase Change- Vaporization
energy from stove = energy required for phase change
No temperature change
Two states of Matter
One state of Matter
Energy from stove causes
increased KE and increased Temperature
Phase Change- Melting
energy from stove = energy required for phase change
No temperature change
Two states of Matter
Energy from stove causes
increased KE and increased Temperature

19. http://www. media. pearson. com
Animation- particles and sublimation

20. Matter changes whenever energy is added or taken away.
Energy is added: Solid  Liquid  Gas
Energy is removed: Gas  Liquid  Solid

21. Image source: http://cse. ssl. berkeley