Download presentation
Presentation is loading. Please wait.
Published byLucy Whitehead Modified over 9 years ago
1
STOVE BURNERS YOU CANNOT MAKE A FLAT TOP ELECTRIC STOVE GAS BURNER ON SLIDE 6
2
2. Features tab Curves Helix and Spiral 1.New Sketch on TOP Plane Sketch a Circle 3. Choose Spiral 6. Revolutions 3 5. Check Reverse direction ELECTRIC COIL BURNER 4. Pitch. 525
3
7. Regenerate 8. Reference Geometry Plane 9. Pick the spiral LINE and the END of the spiral line. 10. New Sketch on Plane 1 Draw a Circle* (*center point of circle starts at red origin arrows)
4
11. Swept Boss/Base 12. Select the Circle and Spiral NOTE: if you get an error, make the circle smaller or use a lower number of spiral revolutions. 10. Regenerate
5
1. New Sketch on TOP plane Draw a Square or Circle 2. Fillet Corners 3. Offset 4. Extrude Boss/Base GAS BURNER
6
5. New Sketch on Surface 6. Draw a Rectangle 9. Fillet 8. Extrude Boss/Base 7. Circular Pattern 10. Material Appearance
Similar presentations
© 2025 SlidePlayer.com. Inc.
All rights reserved.