Presentation is loading. Please wait.

Presentation is loading. Please wait.

Chapter 13 – Solutions - part II Colligative Properties

Similar presentations


Presentation on theme: "Chapter 13 – Solutions - part II Colligative Properties"— Presentation transcript:

1 Chapter 13 – Solutions - part II Colligative Properties
Changes in colligative properties depend only on the number of solute particles present, not on the identity of the solute particles. Among colligative properties are Vapor pressure lowering Boiling point elevation Melting point depression Osmotic pressure

2 Vapor Pressure Because of solute-solvent intermolecular attraction, higher concentrations of nonvolatile solutes make it harder for solvent to escape to the vapor phase. Therefore, the vapor pressure of a solution is lower than that of the pure solvent.

3 Raoult’s Law PA = XAPA where XA is the mole fraction of compound A
PA is the normal vapor pressure of A at that temperature NOTE: This is one of those times when you want to make sure you have the vapor pressure of the solvent.

4 Boiling Point Elevation and Freezing Point Depression
Nonvolatile solute-solvent interactions also cause solutions to have higher boiling points and lower freezing points than the pure solvent.

5 Boiling-Point Elevation
DTb = Tb – T b T b is the boiling point of the pure solvent T b is the boiling point of the solution Tb > T b DTb > 0 DTb = Kb m m is the molality of the solution Kb is the molal boiling-point elevation constant (0C/m)

6 Boiling Point Elevation
The change in boiling point is proportional to the molality of the solution: Tb = Kb  m where Kb is the molal boiling point elevation constant, a property of the solvent. Tb is added to the normal boiling point of the solvent.

7 Freezing Point Depression
The change in freezing point can be found similarly: Tf = Kf  m Here Kf is the molal freezing point depression constant of the solvent. Tf is subtracted from the normal freezing point of the solvent.

8 Freezing-Point Depression
DTf = T f – Tf T f is the freezing point of the pure solvent T f is the freezing point of the solution T f > Tf DTf > 0 DTf = Kf m m is the molality of the solution Kf is the molal freezing-point depression constant (0C/m)

9 Boiling Point Elevation and Freezing Point Depression
Note that in both equations, T does not depend on what the solute is, but only on how many particles are dissolved. Tb = Kb  m Tf = Kf  m

10 DTf = Kf m Kf water = 1.86 0C/m DTf = Kf m
What is the freezing point of a solution containing 478 g of ethylene glycol (antifreeze) in 3202 g of water? The molar mass of ethylene glycol is g. DTf = Kf m Kf water = C/m = 3.202 kg solvent 478 g x 1 mol 62.01 g m = moles of solute mass of solvent (kg) = 2.41 m DTf = Kf m = C/m x 2.41 m = C DTf = T f – Tf Tf = T f – DTf = C – C = C

11 Colligative Properties of Electrolytes
Since these properties depend on the number of particles dissolved, solutions of electrolytes (which dissociate in solution) should show greater changes than those of nonelectrolytes.

12 Colligative Properties of Electrolytes
However, a 1 M solution of NaCl does not show twice the change in freezing point that a 1 M solution of methanol does.

13 van’t Hoff Factor One mole of NaCl in water does not really give rise to two moles of ions. Some Na+ and Cl− reassociate for a short time, so the true concentration of particles is somewhat less than two times the concentration of NaCl.

14 The van’t Hoff Factor Tf = Kf  m  i
Reassociation is more likely at higher concentration. Therefore, the number of particles present is concentration dependent. We modify the previous equations by multiplying by the van’t Hoff factor, i Tf = Kf  m  i

15 Colligative Properties of Electrolyte Solutions
0.1 m NaCl solution 0.1 m Na+ ions & 0.1 m Cl- ions Colligative properties are properties that depend only on the number of solute particles in solution and not on the nature of the solute particles. 0.1 m NaCl solution 0.2 m ions in solution van’t Hoff factor (i) = actual number of particles in soln after dissociation number of formula units initially dissolved in soln i should be nonelectrolytes 1 NaCl 2 CaCl2 3

16 Colligative Properties of Electrolyte Solutions
Boiling-Point Elevation DTb = i Kb m Freezing-Point Depression DTf = i Kf m Osmotic Pressure (p) p = iMRT

17 Change in Freezing Point
Which would you use for the streets of Bloomington to lower the freezing point of ice and why? Would the temperature make any difference in your decision? sand, SiO2 Rock salt, NaCl Ice Melt, CaCl2

18 Change in Freezing Point
Common Applications of Freezing Point Depression Ethylene glycol – deadly to small animals Propylene glycol

19 Change in Boiling Point
Common Applications of Boiling Point Elevation

20 Freezing Point Depression
At what temperature will a 5.4 molal solution of NaCl freeze? Solution ∆TFP = Kf • m • i ∆TFP = (1.86 oC/molal) • 5.4 m • 2 ∆TFP = oC FP = 0 – 20.1 = oC

21 Osmosis Some substances form semipermeable membranes, allowing some smaller particles to pass through, but blocking other larger particles. In biological systems, most semipermeable membranes allow water to pass through, but solutes are not free to do so.

22 Osmosis In osmosis, there is net movement of solvent from the area of higher solvent concentration (lower solute concentration) to the are of lower solvent concentration (higher solute concentration).

23 Osmotic Pressure n  = ( )RT = MRT V
The pressure required to stop osmosis, known as osmotic pressure, , is n V  = ( )RT = MRT where M is the molarity of the solution If the osmotic pressure is the same on both sides of a membrane (i.e., the concentrations are the same), the solutions are isotonic.

24 Molar Mass from Colligative Properties
We can use the effects of a colligative property such as osmotic pressure to determine the molar mass of a compound.

25 Osmosis in Blood Cells If the solute concentration outside the cell is greater than that inside the cell, the solution is hypertonic. Water will flow out of the cell, and crenation results.

26 Osmosis in Cells If the solute concentration outside the cell is less than that inside the cell, the solution is hypotonic. Water will flow into the cell, and hemolysis results.

27 A cell in an: isotonic solution hypotonic solution hypertonic solution

28 Chemistry In Action: Desalination

29 Colloids versus Suspensions
Suspensions of particles larger than individual ions or molecules, but too small to be settled out by gravity. These are mixed, but not dissolved in each other Will settle over time Particles are bigger than 1 micrometer (larger than colloid) Examples: dust in air, muddy water

30 Tyndall Effect Colloidal suspensions can scatter rays of light.
This phenomenon is known as the Tyndall effect.

31 Colloids in Biological Systems
Some molecules have a polar, hydrophilic (water-loving) end and a nonpolar, hydrophobic (water-hating) end.

32 Colloids in Biological Systems
Sodium stearate is one example of such a molecule. These molecules can aid in the emulsification of fats and oils in aqueous solutions.


Download ppt "Chapter 13 – Solutions - part II Colligative Properties"

Similar presentations


Ads by Google