1. © 2008 Cisco Systems, Inc. All rights reserved.CIPT1 v6.0—5-1 Implementing Media Resources, Features, and Applications Implementing Cisco Unified Video Advantage

2. © 2008 Cisco Systems, Inc. All rights reserved.CIPT1 v6.0—5-2 Outline  Cisco Unified Video Advantage Overview  Cisco Unified Video Advantage Communication Flows  Cisco Unified Communications Manager Cisco Unified Video Advantage Configuration  Cisco Unified Video Advantage Installation  Cisco Unified Video Advantage Verification Tools

3. © 2008 Cisco Systems, Inc. All rights reserved.CIPT1 v6.0—5-3 Cisco Unified Video Advantage Overview

4. © 2008 Cisco Systems, Inc. All rights reserved.CIPT1 v6.0—5-4 Cisco Unified Video Advantage Overview  Cisco Unified Video Advantage adds video capabilities to an IP phone.  It uses software on a PC connected to an IP phone.  The PC has a video camera connected.

5. © 2008 Cisco Systems, Inc. All rights reserved.CIPT1 v6.0—5-5 Cisco Unified Video Advantage Components  Unified CM: –Release 4.0(1) with Service Release 2 or later  Cisco Unified IP Phones 794[0125], 796[0125], or 797[015] (or alternatively Cisco IP Communicator 2.0 or later)  PC with video camera and software: –Cisco Unified Video Advantage camera connected via USB –Cisco Unified Video Advantage software

6. © 2008 Cisco Systems, Inc. All rights reserved.CIPT1 v6.0—5-6 Cisco Unified Video Advantage Component Interaction  Cisco Unified Video Advantage software on PC associates with IP phone.  IP phone registers as a video-capable phone.  If both IP phones involved in a call are video-capable, a video call is set up: audio is on the IP phone, video is on the PC.  Mid-call video feature allows video stream to be brought up during the call if video capabilities are added mid-call. Voice Video Association PC with Cisco Unified Video Advantage Installed PC with Cisco Unified Video Advantage Installed SCCP Signaling SCCP Signaling Association

7. © 2008 Cisco Systems, Inc. All rights reserved.CIPT1 v6.0—5-7 Cisco Unified Video Advantage Supported Multimedia Standards  H.263 and H.264 video codec (from 50 kbps to 1.5 Mbps)  Cisco wideband video codecs (7 Mbps)  Supports video formats up to 30 fps: –CIF (352 x 288, 230 x 240) –QCIF (176 x 144, 160 x 120)

8. © 2008 Cisco Systems, Inc. All rights reserved.CIPT1 v6.0—5-8 Cisco Unified Video Advantage Communication Flows

9. © 2008 Cisco Systems, Inc. All rights reserved.CIPT1 v6.0—5-9 Protocols Used by Cisco Unified Video Advantage  Cisco Discovery Protocol: Discovery between IP phone and PC  Cisco Audio Session Tunnel: Association and signaling between IP phone and Cisco Unified Video Advantage software  SCCP: Signaling between IP phone and Unified CM  RTP: Media transport (video to Cisco Unified Video Advantage, audio to phone)

10. © 2008 Cisco Systems, Inc. All rights reserved.CIPT1 v6.0—5-10 Cisco Discovery Protocol How Calls Work with Cisco Unified Video Advantage PC VLAN Phone VLAN 802.1Q “SCCP: Call Signaling (Video and Voice)” Video Packets Audio Packets 1 2 3 4 “Cisco Audio Session Tunnel: Association” Inter-VLAN Routing Signaling Proxy for Video “Cisco Audio Session Tunnel : Call Signaling (Video Only)” Inter-VLAN Routing

11. © 2008 Cisco Systems, Inc. All rights reserved.CIPT1 v6.0—5-11 Video Call Bandwidth for Audio and Video Channels  Video call includes two channels: –Audio channel –Video channel  The bit rate available for the video channel depends on the negotiated audio codec and the overall video call speed. 320 kbps 376 kbps Video Call Speed at 384 kbps with G.711 Video Call Speed at 384 kbps with G.729 64 kbps 8 kbps AudioVideo

12. © 2008 Cisco Systems, Inc. All rights reserved.CIPT1 v6.0—5-12 Cisco Unified Communications Manager Cisco Unified Video Advantage Configuration

13. © 2008 Cisco Systems, Inc. All rights reserved.CIPT1 v6.0—5-13 Unified CM Cisco Unified Video Advantage Configuration Procedure 1.Configure regions with the maximum audio codec and video call speed to be used per video call. 2.Configure the maximum allowed bandwidth used by video calls between different locations. 3.Configure the IP phone in Unified CM to support Cisco Unified Video Advantage. 4.Verify Cisco Unified Video Advantage support on the IP phone.

14. © 2008 Cisco Systems, Inc. All rights reserved.CIPT1 v6.0—5-14 Step 1: Setting the Maximum Audio Codec and Video Call Speed Allowed Per Video Call Sets audio codec with the highest allowed codec bit rate. Applies to audio channels of audio and video calls. System > Region Sets the maximum video call speed. Includes audio and video channel).

15. © 2008 Cisco Systems, Inc. All rights reserved.CIPT1 v6.0—5-15 Step 2: Setting the Maximum Allowed Bandwidth Used by Video Calls for Locations Sets the maximum audio bandwidth for a location. Applies to audio-only calls only, not to audio channel of a video call. System > Location Sets the maximum video bandwidth for a location. Applies to audio and video channels of video calls.

16. © 2008 Cisco Systems, Inc. All rights reserved.CIPT1 v6.0—5-16 Step 3: Required Phone Configuration Settings for Video Support PC Port (enabled by default): Must be enabled. Device > Phone Video Capabilities (disabled by default): Must be enabled.

17. © 2008 Cisco Systems, Inc. All rights reserved.CIPT1 v6.0—5-17 Step 4: Verification of Phone Configuration  A video-enabled IP phone shows a small camera on its screen.  The symbol is visible after the phone is configured to support video calls: –It does not indicate that Cisco Unified Video Advantage has been associated with the IP phone.

18. © 2008 Cisco Systems, Inc. All rights reserved.CIPT1 v6.0—5-18 Cisco Unified Video Advantage Installation

19. © 2008 Cisco Systems, Inc. All rights reserved.CIPT1 v6.0—5-19 Cisco Unified Video Advantage Installation Procedure 1.Consider hardware requirements 2.Consider software requirements 3.Install Cisco Unified Video Advantage software and hardware

20. © 2008 Cisco Systems, Inc. All rights reserved.CIPT1 v6.0—5-20 Step 1: Cisco Unified Video Advantage Hardware Requirements  PC: –At least 1.9 GHz CPU –At least 512 MB memory –At least 100 MB free disk space –At least one USB port –Connected to a Cisco Unified IP Phone 794[0125], 796[0125], or 797[015] or colocated with Cisco IP Communicator  Cisco VT Camera: –Connected to a USB port of the PC

21. © 2008 Cisco Systems, Inc. All rights reserved.CIPT1 v6.0—5-21 Step 2: Cisco Unified Video Advantage Software Requirements  Operating system: –MS Windows 2000 with Service Pack 4 or later –MS Windows XP with Service Pack 2 or later  Cisco Unified Video Advantage software –Downloaded from Cisco.com

22. © 2008 Cisco Systems, Inc. All rights reserved.CIPT1 v6.0—5-22 Step 3a: Cisco Unified Video Advantage Installation – Preparation Checklist  Ensure that the Cisco IP phone or Cisco IP Communicator is registered.  Ensure that the Cisco IP phone or Cisco IP Communicator is video-enabled.  Ensure that the PC is connected to the IP phone and verify IP connectivity between IP phone and PC (not needed with Cisco IP Communicator): –Check reachability using ping –Ensure that Cisco Audio Session Tunnel protocol is not filtered between PC and IP phone

23. © 2008 Cisco Systems, Inc. All rights reserved.CIPT1 v6.0—5-23 Step 3b: Cisco Unified Video Advantage Installation Install Cisco Unified Video Advantage with Installation Wizard. Installation is complete. 4 1 Plug in camera. 2 Camera will be found automatically. 3

24. © 2008 Cisco Systems, Inc. All rights reserved.CIPT1 v6.0—5-24 Cisco Unified Video Advantage Verification Tools

25. © 2008 Cisco Systems, Inc. All rights reserved.CIPT1 v6.0—5-25 Cisco Unified Video Advantage Verification of IP Phone Association  After starting the Cisco Unified Video Advantage software, verify the status of the connection to the IP phone or Cisco IP Communicator. Camera Associated with Cisco IP Communicator, Connection Successful Camera Associated with IP Phone, Connection Not Successful

26. © 2008 Cisco Systems, Inc. All rights reserved.CIPT1 v6.0—5-26 Cisco Unified Video Advantage Verification of Camera  After verifying the camera connection status, run a video check, and you should see the camera input in both windows, the remote and the local view.

27. © 2008 Cisco Systems, Inc. All rights reserved.CIPT1 v6.0—5-27 Active Call Verification with the Diagnostic Tool  You can open a call diagnostic window by right-double-clicking the Cisco Unified Video Advantage application window.  The diagnostic window allows you to monitor Cisco Discovery Protocol packets, Cisco Audio Session Tunnel packets, and active call statistics.

28. © 2008 Cisco Systems, Inc. All rights reserved.CIPT1 v6.0—5-28 Summary  Cisco Unified Video Advantage adds video capabilites to Cisco IP phones by using software and camera on a PC attached to the IP phone.  Cisco Unified Video Advantage discovers the IP phone by listening to Cisco Discovery Protocol messages and uses the Cisco Audio Session Tunnel protocol to associate with the IP phone and to send and receive signaling messages.  In order to enable Cisco Unified Video Advantage, IP phones have to be video-enabled and regions and locations must be configured to permit video calls.  Before installing Cisco Unified Video Advantage on the PC, verify hardware and software requirements.  Cisco Unified Video Advantage includes tools to verify the association with the IP phone, check the camera, and perform diagnostics.

29. © 2008 Cisco Systems, Inc. All rights reserved.CIPT1 v6.0—5-29