1. Stop Watch Sean Hicks Dongpu Jin ELEC 307 Project 2 Instructor: Alvaro Pinto April/12/2011

2. Overview Background and Theory Specification Explanation Summary Work to Be Done Conclusion

3. Background and Theory We are modeling a stop watch using a FPGA board. This stop watch has the most commonly used functionalities: ◦ Count, Pause and Reset.

4. Background and Theory This is a hardware and software co-design project. Models are written in VHDL. Individual model and the entire system will be tested using simulators. Design will be implemented on a FPGA board.

5. Specification Hardware: Altera DE II board with: Cyclone II FPGA On board 50MHz internal clock On board seven segments LEDs On board push buttons Software: Altera Quartus ModelSim VHDL

6. Specification 6 Push buttons FPGA 7-Seg LEDs 50MHz Clock

7. Explanation Primarily Design: ◦ Behavioral Model ◦ State Transition

8. Explanation We have tested this model using ModelSim, and it works fine.

9. Explanation This model does not work in Quartus. So we moved to develop a Structural Model. Inputs: reset, run, pause, 50MHz internal clock. Outputs: five 7-segment LEDs display each digits.

10. Explanation Components: ◦ 10Hz Clock Converter, mod 10 counter, mod 6 counter, 7-seg decoder.

11. Summary Each component and the entire system has been tested using waveform in Quartus. The entire system also has been tested on FPGA.

12. Work to Be Done We have done the experiment part of this project. Just need to write the report.

13. Conclusion This concludes our presentations of Project 2- Stop Watch. Any questions?

14. Conclusion Thanks for your attention!