1. Atmospheric Thermodynamics – III Adiabatic Processes
Leila M. V. Carvalho
Dept. Geography, UCSB

2. Review
We learned that there are processes that occur at constant pressure, others at constant volume (no work done or received)
We also learned that in other situations volume and pressure may change
We defined the concept of Enthalpy (sensible heat) h=CpdT, which is the sensible heat transferred at constant pressure.

3. Consider a dry atmosphere (no clouds)
Pressure
Parcel move and can change pressure as it rises or sinks. A few physical concepts to remember:
IF dq=0 (no heat gain or lost )
Variation Geopotential
First Law of Thermodyn.
Enthalpy
Heat
Dry Static Energy: Conservative

4. Adiabatic Processes
If a material undergoes a change in its physical state (e.g., pressure, volume, or temperature) without any heat being added to it or withdrawn from it, the change is said to be ADIABATIC
dq=0

5. Suppose an Isothermal contraction
State A
State B
F=pA
Every state of the gas between A and B will be represented by the red line above connecting A to B

6. Example of Adiabatic Compression
State A
During the adiabatic compression, the internal energy increases because:
dq = du + pdα and dq=0, so du= - pdα
Compression: dα < 0 du > 0
State C
In conclusion, Temperature should rise: TC> TB and pC> pB

7. Examples where Adiabatic Compression takes place
In the center of High pressure systems (low levels)

8. Local scale: Santana winds Sundowner winds
Adiabatic compression TC

9. Concept of an Air parcel
Molecular mixing is important only within a centimeter of the surface
At intermediary levels (up to ~ 105km) all mixing in the vertical is accomplished by the exchange of macroscale “air parcels” with horizontal dimensions ranging from millimeters to the scale of the Earth itself

10. Infinitesimal parcels
Thermally insulated from its environment (temperature changes adiabatically as it rises or sinks. It is always in hydrostatic Equilibrium
Moves slowly enough that the macroscopic kinetic energy of the air parcel is a negligible fraction of its total energy
-(1/ρ)dp/dz
dq=0 g

11. Dry adiabatic Lapse rate
T=9 oC
T=8 oC
T=7 oC
Is the rate of change of temperature with height of a parcel of dry air satisfying the conditions described in the previous slide
Dividing through by dz and using (20)
Remember: variations in oC or K are equivalent

12. Important Note
T=9 oC
T=8 oC
T=7 oC
7oC
8oC
9oC
Γd is the rate of change of temperature following a parcel of dry air that is being raised (or lowered) adiabatically in the atmosphere.
The environmental lapse rate (the one that is measure by a radiosonde) averages 6-7 K km-1 in the troposphere, but it takes on a wide range of values at individual locations

13. Potential Temperature θ
Is defined as the temperature that the parcel of air would have if it were expanded or compressed adiabatically from its existing pressure and temperature to a standard pressure po (generally taken as 1000hPa)
This concept is useful for many reasons. One of them is to compare masses of air from different altitudes and from different regions too. We will se more about this later

14. How to compute potential temperature
Integrating upward from po (1000hpa where T= θ) to p, we obtain:
Solving the integral: or

15. Final Expression: Taking the antilog of both sides: OR
Called the Poisson Equation ( French Mathematician – )
R≈Rd= 287 J K-1 kg-1 and cp ≈ 1004 J K-1 kg-1
R/cp ≈ 0.286

16. For example 250hPa 750hPa 1000hPa T=-51C Θ< 57 Same Temperature
Colder
750hPa
Θ< 57
1000hPa

17. Considerations
Parameters that remain constant during certain transformations are said to be conserved. Potential temperature is a conserved quantity for an air parcel that moves around in the atmosphere under adiabatic conditions.
Potential temperature is an extremely useful parameter, since atmospheric processes are often close to adiabatic (θ remains essentially constant)

18. Thermodynamic Diagrams
We learned in physics to deal with thermodynamic diagrams that show pressure against volume, for instance. In this diagrams we can represent processes that are isothermal, adiabatic, etc.
In atmospheric sciences it is ideal to represent pressure as a vertical axis (logarithm scale), temperature as another axis and the adiabatic processes as straight lines in a graphic form. Knowing the relationships among variables it is possible to construct a diagram like this. We call it as pseudoadiabatic charts.

19. Complete pseudoadiabatic chart.
Pressure increases downward and is plotted in a distorted scale (represents p0.286).
The blue area is of interest for meteorological computations.
The sloping lines are dry adiabats.
At 1000hPa the actual temperature is the potential temperature
Region of interest
(more definitions on how lines are obtained and respective equations can be seen in Chap 3, pg. 78

20. Skew-T – log p diagrams
In the pseudoadiabatic chart, isotherms are vertical and dry adiabats (constant θ) are oriented at an acute angle relative to isotherms
Changes in temperature with height in the atmosphere generally lie between isothermal and dry adiabatic, and therefore most temperature soundings lie within a narrow range of angles when plotted on a pseudoadiabatic chart.
Solution: pressure is in –lnp and temperature is in the abscissa (x)
x=T+(constant)y= T –(constant)ln p
In the Skew-T log-p charts are straight parallel charts that slope upward

21. Exercise 3.5 (a)
A parcel of air has a temperature of -51oC at 250hPa level. What is its potential temperature?
a) locate the original state of the parcel at pressure 250hPa and temperature -51oC (look at temperatures at the top of the chart in red)
b) read the label of potential temperature on the dry adiabat (brownish color lines) (find value 60oC)

22. Exercise 3.5 (b)
What temperature will the parcel of the problem (a) have if it is brought into the cabin of a jet aircraft and compressed adiabatically to a cabin pressure of 850ha?
The temperature acquired by the ambient air if it is compressed adiabatically to a pressure of 850hPa can be found from the chart by following the dry adiabat that passes through the point located by 250hPa and -51oC down to a pressure 850hPa and read the temperature. It is 44.5oC. (air of a jet aircraft at cruise altitude has to be cooled by about 20oC to provide a comfortable environment

23. Exercise for training
Suppose that the ground level pressure in Santa Maria is 900hPa and temperature is 20oC. Suppose that a sundowner (downslope wind) occurs in these conditions. What should be the expected temperature downhill in Santa Barbara, supposing that pressure in SB is ~ 1000hPa?
Use the skew-t log-p to answer this question. Find the initial condition in Santa Maria. Suppose that downslope winds descend the mountains following a dry adiabatic processes. Use the dry adiabat that pass through the initial condition to find the temperature in SB

24. Exercise 3.27
The pressure and temperature at the level which jet aircraft normally cruse are typically 200hPa and -60oC. Use the skew-t lnp chart to estimate the temperature of this air if it were compressed adiabatically to 1000hPa. Compare your answer with an accurate computation.

25. Water Vapor in Air

26. We have indicated the presence of water vapor in the air through the vapor pressure e that it exerts and we have introduced its effect on the density of the air by introducing the concept of virtual temperature.
However, the amount of water vapor present in the air may be expressed in many different ways.

27. Moisture Parameters

28. The mixing ratio is a measure of the mass of water vapor mv relative to the mass of the other gases of the atmosphere md (dry air). (g/kg)
Remember that to solve numerical exercises w must be expressed dimensionless (kg/kg)
Typical ranges: a few grams/kg in midlatitudes and around 20gkg-1 in the tropics

29. Specific humidity expresses the mass of water vapor existing in a given mass of air [g/kg]
Because the magnitude of w is only a few percent, it follows that the numerical values of w and q are nearly equivalent

30. Exercise 3.6
If air contains water vapor with a mixing ratio of 5.5 g/kg and the total pressure is hPa, calculate the vapor pressure e
The partial pressure exerted by any constituent of a mixture of gases is proportional to the number of moles of the constituent in the mixture. Therefore:
n= number of moles
Where Mw,d is the Molecular weight of the water and dry air

31. Saturation Vapor pressure
Saturated
Unsaturated
e=0
T,e
T,es
Consider a hypothetical jar containing pure water with a flat surface
and an overlying volume that initially contains no water vapor (a).
As evaporation begins, water vapor starts to accumulate above
the surface of the liquid. With increasing water vapor content,
the condensation rate likewise increases (b). Eventually, the
amount of water vapor above the surface is enough for the rates
of condensation and evaporation to become equal.
The resulting equilibrium state is called saturation and the water vapor pressure is called saturation vapor pressure over a plane surface of pures water at temperature T(c).

32. Suppose that circles represent water vapor molecules
Saturation for a given Temperature T
Evaporation Condens
Rate Rate

33. Similar behavior can be observed for pure ice
T, esi
T, ei
ice
At any given temperature, the rate of evaporation from cie is less than for water, es(T) > esi(T)

34. Both es(T) and esi(T) increase with temperature
Maximum difference T~ -12oC
These differences explain why if an ice particle is in water-saturated air in a cloud it will grow due to deposition of water vapor upon it
Variations with temperature of the saturation (equilibrium) vapor pressure es over a plane surface of pure water (red) and difference between es(T) and esi(T)

35. Saturation Mixing Ratios
The saturation mixing ratio with respect to the water is defined as the ratio of the mass mvs of water vapor in a given volume of the air that is saturated with respect to a plane surface of pure water to the mass md of the dry air (g/kg)
(61)
Water vapor and dry air both obey the ideal gas equation
Partial density of the dry air
Partial density of the water vapor required to saturate air with respect to water at temp T

36. Final expression for ws
Remember:
For the range of temperature observed in the Earth’s Atmosphere, p>> es:
(63) Depends only on temperature and pressure. Represented as dashed lines in the Skew-T lnp

37. Relative Humidity, Dew Point and Frost Point

38. RH = (specific humidity/saturation specific humidity) X 100%
Relative humidity, RH, relates the ACTUAL amount of water vapor
in the air to the maximum possible at the current temperature.
RH = (specific humidity/saturation specific humidity) X 100%
Saturation for cold air
(64)
More water vapor can exist in warm air than in cold air,
so relative humidity depends on both the
actual moisture content and the air temperature.
Saturation for warm air
If the air temperature increases, more water vapor
can exist, and the ratio of the amount of water vapor
in the air relative to saturation decreases.

39. Dew
Dew is moisture condensed upon surfaces, specially during the night (why??)
The dew point is the temperature to which the air must be cooled at constant pressure to become saturated with respect to a plane surface of pure water. In other words, dew point the temperature at which saturation mixing ration ws with respect to liquid water becomes equal to the actual mixing ration w.

40. Suppose that circles in red represent the actual mass of water vapor and in green the mass of the water vapor necessary for the air to become saturated
Saturation for a warmer Temperature
What should happen in order that the actual mass of water vapor saturate the air?
T must decrease
Evaporation Condens
Rate Rate
Evaporation Condens
Rate Rate
Now this is the new saturation mixing ration
RH=100%

41. How to express RH with respect to Td:
Simple Rule of Thumb for converting RH to a dew point depression (T-Td) for moist air (RH >50%): Td decreases by ~1C for every 5% decrease in RH (starting Td=dry bulb temperature (T) when RH=100%). For example: If RH is 85%, what is the depression?

42. Distribution of mean dew points across the U.S. in January.

43. Distribution of mean dew points across the U.S. in July.

44. Frost Point
Is defined s the temperature to which air must be cooled at constant pressure to saturate it with respect to a plane surface of pure ice. Mathematical definitions are similar to dew point

45. Exercise 3. 8: Air at 1000 hPa has a mixing ratio of 6g/kg
Exercise 3.8: Air at 1000 hPa has a mixing ratio of 6g/kg. What are the relative humidity and dew point of the air?
Use the Skew-t lnp chart to answer this question. Use RH=100(w/ws) and Td is the temperature at w.