1. How To Connect WinRunner to Quality Center In this module you will learn how to connect WinRunner to Quality Center.  This training module will take you approximately 5 minutes to complete. At the end of it you will know how to: Reconnect WinRunner to Quality Center Note: To leave this training module, click on the located on the top far right hand corner of the screen.

2. Please use the navigation buttons provided to move through the training modules Click on the arrow above to return you to the previous screen

3. Click on “Add-ins Page”

4. Click on “Mercury Quality Center Connectivity”

5. Click on “Download Add-in”

6. Click on “Run”

8. When the installation of the add-in is completed, you will be informed by this message. Click to progress Training tip Click on “OK”

9. In WinRunner, click on “Tools” In WinRunner, click on “Tools” Click on “Quality Center Connection”

10. If this box is blank, or contains something else, type in https://qualitycenter.apps.anz/qcbin https://qualitycenter.apps.anz/qcbin Click to progress Training tip Click on “Connect”

11. Click on “Yes”

12. Enter the correct information into these boxes Click to progress Training tip Click on “Connect”

13. You have now connected WinRunner to Quality Center. Click on “Close” to begin working You have now connected WinRunner to Quality Center. Click on “Close” to begin working

14. You have now completed this Training Module To exit, click on the located on the top far right hand corner of the screen. FAQ module developed by Alex Williams Contact Alex for your FAQ requirements