1. DriveAP 1.2 & 2.1
DriveWare®

2. DriveAP key features Extremely easy to use
Upload, edit, download program
Possibility to monitor signals on-line
Print documentation
Includes 3 operating modes:
Stand alone (no drive connected)
On-line (all changes are written immediately to the drive)
Off-line (upload from drive, edit off-line, download to drive)
Uses DDCS communication

3. DriveAP is now available in two versions
Non used blocks are hidden
Block connection with few clicks
Supports 15 blocks
Factory codes
3AFE (CD)
3AFE (CD + PC Card kit)

4. DriveAP example 1 User can easily make small changes to basic software
Relay output selection list does not contain required setting. RO1 needs to be energized when “Encoder err” warning is given.
No function blocks are required, just use the pointer.

5. DriveAP example 2
A measuring device is connected to AI1 of analogue extension module. Drive must create a warning in case input current goes above 6 mA and a fault if input goes above 15mA.

6. DriveAP example 3 Create a function that doesn’t exist in a PC tool
Enable DriveWindow to monitor alarm bit from drives status word. Add following block to e.g. 12 ms cycle time and monitor parameter instead of 3.02 (status word).

7. DriveAP 2 Totally new block programming tool
All data stored to drives flash memory including block location, comments, symbols etc

8. DriveAP 2
With Multi Block Programming Application one is able to locate freely over 200 blocks including
I/O blocks (AI, AO, DI, DO, EXT AI, …)
Functions blocks (ABS, ADD, AND, BSET, COMPARE, COUNT, …)
Communication blocks (Profibus, Master/Follower)
Comment blocks
5 pages / time level available
Separate info page describes block functionality
Factory codes
3AFE (CD)
3AFE (CD + PC card kit)