1. Effects of Tracking Limitations On Jet Mass Resolution Chris Meyer UCSC ILC Simulation Reconstruction Meeting July 3, 2007

2. Motivation No one has yet studied how tracking limitations effect Jet Reconstruction. Limit in P T reach Limit in cos θ reach Non prompt tracks (K S ) Photon conversion in tracker material

3. Approach Use e + e -  q qbar at E cm = 500 GeV (turn off ISR so that events are evenly distributed) Find “perfect jets” from MC truth particles that: –Originate within 1cm and terminate outside 1cm from the origin –Are FINALSTATE or INTERMEDIATE –Are not backscatter –Confirmed  E i = 500 ± a few GeV for this selection Using a y cut of 0.07 select events with only 2 jets Calculate Jet/Jet invariant mass

4. Approach cont. Apply tracking limitation (e.g. P T > 0.5 GeV cut) Find jets with cut applied. If no y cut gives two jets, toss event (<1%) Compare Jet/Jet mass with “perfect” reconstruction. Accumulate RMS ( δm) of Jet/Jet mass degradation.

5. Goal For Maximum Degradation: 1% Need to distinguish W’s from Z’s using the Jet/Jet invariant mass from high energy Jets. Our sample has high energy Jets but a Jet/Jet mass of 500 GeV (rather than 100 GeV). Taking two jets of the same energy we find the invariant mass and associated error go as: m 2 = 2 (1 – cos θ ) p 2 δm 2 = 2 (1 – cos θ ) δp 2 Error on momentum is constant wrt mass, to eliminate the mass dependence from cos θ form fractional error on mass, so that δm 2 / m 2 = const. wrt mass, so that δm / m = const. wrt mass also To distinguish between a Z and W 10% resolution is required, and to be outside 3 standard deviations brings it down to 3%. Finally to disregard error on tracking we require the error to be 1%. Using 500 GeV uds events, m = 500, which means δm ≤ 5 To keep from degrading W and Z seperation we need an error on invariant mass of less then 5 GeV.

6. Cuts on charged track P T P T cut of 0.75 GeV δm = 5.62 GeV P T cut of 0.5 GeV δm = 3.49 GeV

7. K Shorts Finding NO K Shorts δm = 43.61 GeV Finding 90% of K Shorts δm = 11.11 GeV But RMS is still dominated by tails…

8. K Shorts Finding 90% K Shorts (cutting top 3%) δm = 2.86 GeV

9. Gamma’s Finding NO Photons < 1 GeV δm = 3.45 GeV Finding 90% of Photons < 1 GeV δm = 0.65 GeV Low energy photons that convert will miss the calorimeter. How many low energy ( < 1 GeV ) photons do we need to find then?

10. Gamma’s Finding NO Photons δm = 69.28 GeV Finding 90% of Photons δm = 14.96 GeV How many photons (no energy cut) do we need to find?

11. Conclusions Looking at simple cuts on Jets we have found: The P T range of any proposed ILC tracker looks fine. We have to find a good percentage (90%) of the K shorts. Low energy photons don’t play an enormous role, but when you include higher energy photons you need to find them. Next we plan on running over cos θ cuts and put more stringent cuts on material parameters. This should be accomplished within the next week.