1. Project Overview- Strong Arm ECEN 4610, Spring 2005 Thaine Hock Matt Corne Sammit Adhya Luz Quiñónez

2. Adhya, Corne, Hock, Quinonez2 Project Goals To design and build the controlling electronics for a six- axis robotic arm that can be controlled through the use of simple finger motions Arm will allow paraplegics to control robotic arm in three dimensions Proof of concept of a larger scale device and training system

3. Adhya, Corne, Hock, Quinonez3 Outline of Approach Finger Sensors Micro Controller FPGA Servo Controller Arm Magnetic Sensors User Interface

4. Adhya, Corne, Hock, Quinonez4 Finger Sensors Polar Coordinate Control System –Push Buttons and Limit Switches –Six directions of control –Grip and Release

5. Adhya, Corne, Hock, Quinonez5 FPGA Uses Magnetic Sensor as Inputs –Determine Initial Block Positions Send Polar Coordinate Position to Micro Controller Using Memory- Mapped Registers

6. Adhya, Corne, Hock, Quinonez6 Micro Controller The Brain! Boahahahahaha!!! –Freescale 68HC912DG128A 8KB SRAM 2KB EEPROM 128KB FLASH SCI, SPI ADC Onboard 69 I/O Pins

7. Adhya, Corne, Hock, Quinonez7 Servo Controller Control Six Servos Using Serial Interface –Generates PWM signals to servos

8. Adhya, Corne, Hock, Quinonez8 Arm Lynxmotion Robotic Arm –Six degrees of freedom Base rotation, shoulder, elbow, wrist motion, wrist rotate, and a functional gripper

9. Adhya, Corne, Hock, Quinonez9 Magnetic Sensors Place Magnets Inside Blocks Build Magnetic Flux Detection Grid –Detect location of block using triangulation

10. Adhya, Corne, Hock, Quinonez10 Division of Labor Finger Sensor –Thaine FPGA Implementation –Sammit PCB and Micro controller –Thaine Robotic Arm Algorithms –Sammit and Matt Magnetic Sensor and Block Detection –Luz User Interface –Matt

11. Adhya, Corne, Hock, Quinonez11 Schedule

12. Adhya, Corne, Hock, Quinonez12 Risks and Contingency Plan Mapping cylindrical coordinates to servo positions may prove difficult Magnetic sensors not sensitive enough to detect block positions –Possible use of ultra-sonic sensors

13. Adhya, Corne, Hock, Quinonez13 Economic Aspects and Marketability Training unit cost is relatively low Practical arm cost will be very high Moderate demand Possibility of medical insurance covering some/most of the cost Approx 7800 Spinal Cord Injuries each year, many of them could benefit 1 1:http://www.sci-info-pages.com/facts.html

14. Adhya, Corne, Hock, Quinonez14 Sustainability and Manufacturability Parts widely available for control circuitry. Can be used with many different arms Effect of component tolerances are low except for a small handful Auto-test routines in software Complies with regulations and is safe to operate (training version)

15. Adhya, Corne, Hock, Quinonez15 Environmental Impact Pros Can be mostly lead- free No byproducts Cons Would need large battery (most likely toxic) Consumes large amounts of power

16. Adhya, Corne, Hock, Quinonez16 Impact on Society Full scale device would allow some handicapped persons to be able to perform more physical tasks, qualifying them for more job opportunities

17. Questions? Thanks!