1. Finite Element Analysis by Pro- Mechanica

2. Steps in FEA using Pro-Mechanica Step 1: Draw part in Pro-Engineer Step 2: Start Pro-Mechanica Step 3: Choose the Model Type Step 4: Apply the constraints Step 5: Apply the loads Step 6: Assign the material Step 7: Run the Analysis Step 8: View the results by post-processing

3. Step 1: Creation of the part Use Protrusion by Sweep to create this part (bar.prt)

4. Step 2: Starting Pro-Mechanica In Pro-Engineer window, go to Applications  Mechanica to start Pro- Mechanica. The part (bar.prt) will be loaded in Pro- Mechanica with a new set of icons for Structural, thermal Analysis

5. Step 3: Choosing the model type In Mechanica menu, select Structure  Model  Model Type Four different models can be created: –3D Model –Plane Stress –Plane Strain –2D Axisymmetric We will select 3D Model

6. Step 4: Applying the Constraints Create a new constraint by Model  Constraints  New  Surface Give a name for the constraints (fixed_face) and select the surface to be constrained Specify the constraints (in our case will be fixed for all degrees of freedom) Preview and press Ok

7. Step 5: Applying the loads Similar to Constraints, create a new load by Model  Load  New  Surface Give a name for the applied load (endload) Select the surface where the load will be applied Specify the loads (Fx:500, Fy:-250, Fz:0) Preview and press Ok

8. Step 6: Assigning the material Model  Materials A window will pop up with the list of Pro- Mechanica materials. Add the required material and then assign the material to the part. Click on Edit if any change in material properties are to be made. Press Ok

9. Modeled part with constraints and loads

10. Step 7: Running the Analysis In Mechanica menu, select Analysis Select File  New Static in “Analysis and Design Studies” dialog box and give a name for the analysis (bar). The constraints and loads are automatically loaded. In Convergence tab, select Quick Check to check for errors and then select Multi-pass adaptive for the reliable and accurate results. Change the order of the polynomial and percentage of convergence as required. Finally, click on Run icon to start the analysis (click on Display Study Status to view the current status and completion of the analysis)

11. Step 8: Viewing the results For post-processing, select Results from Pro- Mechanica window A new window will open, and click on “Insert a New Definition” icon. In the dialog box, select the folder where the analysis is saved. Select Fringe as Display type, Stress as Quantity and von-mises as the stress component to display Similarly, other quantities can be displayed in one window.

12. Post-processing Results