1. Standard Rung 30mm 385mm 350mm 10mm 111mm 2mm47mm77mm107mm 147mm177mm207mm 236mm272mm302mm332mm355mm 378mm

2. Top Rung Down 140mm 154mm54mm 68mm 135mm We need 8 or 9 of these made from standard rungs

3. Second Rung 194mm 10mm 2mm We need 16 of these made from standard rungs

4. Half Rung Up 154mm54mm We will have to machine these from the current half up types if they have been made in sufficient numbers we need 8 or 9

5. Half Rung Down These may well have been made already we need 8 or 9

6. data 30mm 36mm 215mm 394mm 573mm752mm931mm1110mm1289mm Down Type Column 6mm 52mm HRD 2nd Std TRD

7. data 30mm Up Type Column 52mm7mm 82mm 261mm440mm619mm798mm977mm1156mm 1335mm 2nd Std HRU

8. End Pieces

9. Card Layout 30mm 20mm 100mm 3mm 24mm 3mm 90mm 10mm 23mm 30mm 423mm HPDs Level-0 Fibre Channel Low Voltage High Voltage

10. Voltage solution HV power out of column with minimum of bending Other Cables can make S bend reasonably easily For columns close to top of crate HPDs

11. End Pieces Voltage solution HV power LV power HV mon LV mon Si Bias

12. Voltage solution All cables can exit form the back of the column if there is the space available For columns far from the top of crate This also allows the voltage patch panel to be in line with the cable port in the shield

13. Low Voltage Power

14. Low Voltage Sense Two 2 pin lemo cables – with approximately cat5 thickness and stiffness

15. High Voltage Power Have to redesign end piece to allow these very thick cables to exit column satisfactorily. Can unbolt from patch panel and feed through so not too much compliance required.

16. HV monitoring Goes to one 15pin sub D – may be a problem with different lengths of cables

17. Silicon Bias A single lemo cable – Can it come from the C board?

18. SPECS/ECS Single RJ45 Network Cable

19. Temperature Monitoring Flat cable going to 37pin Sub-D

20. Data Fibres 24 Fibres going to 2 break out boxes. Need to be careful of bending just after boxes. Need to be very careful of loop. Spare fibres go down front U channel by HPDs. Concerned about space for loop before patch panel. Doesn't show looping round the Lo boards to use uip fibre length

21. TTC Fibres 7 TTC control fibres – occupying the same space as the data fibres. Loop could be sooner to avoid too much conflict as no break out boxes to worry about.