1. ATLAS End-Cap C Proposed Transport Box P Cooke 15 June 2005

2. Requirements Support using transport frame only Support using transport frame only Isolate Thermal plug from transport box Isolate Thermal plug from transport box Temperature controlled truck Temperature controlled truck Rear door opening - 2.7M high x 2.45M wide Rear door opening - 2.7M high x 2.45M wide Load onto truck with fork-lift Load onto truck with fork-lift Recommended transport company - Danzas Recommended transport company - Danzas

4. Method Raise end-cap assembly frame 225mm to clear lowest point of transport frame Raise end-cap assembly frame 225mm to clear lowest point of transport frame Necessary to remove assembly frame floor (reducing supported weight) Necessary to remove assembly frame floor (reducing supported weight) Lower transport frame 90mm (extend wheel brackets) Lower transport frame 90mm (extend wheel brackets) Manufacture strong pallet Manufacture strong pallet Construct protective frame and box onto pallet Construct protective frame and box onto pallet

5. Original Assembly/Transport frames

6. Assembly frame raised 225mm and wheels raised 90mm

7. Inner Protective Frame assembled from Bosch Profile

8. Inner frame covered with varnished 12mm ply-wood

9. Top and Underside views of steel pallet

10. Assembly positioned over pallet

11. Wheels transferred onto pallet Outer frame assembled using Bosch profile attached to pallet

12. Outer frame covered with 25mm varnished ply-wood

13. Cut-away section of complete assembly