1. Development of the IF2 Chain for the FPU of the HIFI Instrument Alexander Megej July 1 st, 2003, Groningen

2. Introduction I  Second Stage of the IF-Amplification Chain

3. Introduction II Two different amplifier types: Bands 1  5 (4  8 GHz) Bands 6H&L (2.4  4.8 GHz)

4. Activities Planned LNA Design 2 stage LNA for the altered frequency range of the Band 6√ 3 stage LNA for the Bands 1-5 (4  8 GHz) √ Re-design of signal combiners Soft substrate: RT6002 of Rogers (SRON).√ Alternative: TMM10i with the existing ETH design√ Development and testing of amplifiers to be completed by the end of 2002 √ SRON performs mechanical design of the IF-2 box in co- operation with Mecom, NL √ ITT-Package definition √ Design and technology transfer to an industrial partner starting in 2003 

5. Activities Planned Manufacturing of the Final Amplifier DMs √ /  Issue of ITT √ Assembling of the IF-2 DMin progress Transfer of the Design and Technology to an Industrial Partner 

6. “Final” DM Amplifiers Designed for CRYO7 Devices Manufactured Employing the HEMTs from the HERSCHEL Wafer iHER1AZ1 4200-071 Slightly Lower Gain Input Matching Problems Noise Performance

7. LNA for Bands 1  5 Three-stage design using TRW InP HEMTs

8. LNA for Bands 1  5

10. Summary of Measured Results valueunit Power Gain 33  35.4 dB Gain Ripple±1.2dB Input Reflection< -7dB Output Reflection<-12dB Mean Noise Temp62*K Power Consumption6mW/amp * Measurements @RT

11. LNA for Band 6 Three-stage design using TRW InP HEMTs

12. LNA for Band 6

13. LNA for Bands 6

14. LNA for Bands 6 H&L Summary of Measured Results Version #1Version #2unit Power Gain 36  3938.7  43.7 dB Gain Ripple±1.5±2.5dB Input Reflection< -10< -9dB Output Reflection<-15<-10dB Mean Noise Temp54*47*K Power Consumption66mW/amp * Measurements @RT

15. Critical Points: HEMTs

16. To achieve the necessary input matching, attenuator were proposed at the input. This reduces the gain, which just meets the specs. PROPOSAL: to reduce the specs to -10 dB at the input (min. of -16 dB is still seen @ the output of IF-1 due to cable losses) Relax the DC-consumption requirement (15 mW instead of 12 mW allowed) Use of isolators (Unacceptable due to higher mass )

17. Further Activities Possible Re-Design Manufacturing of the Final Amplifiers Depends on the decision, which HEMTs have to be used Assembling of the IF-2 DM Transfer of the Design and Technology to an Industrial Partner QM/FM/FS Programme

18. Realistic Schedule I ActivityDate DM AssemblyAugust 2003 Industrial Kick-Off MeetingAugust 2003 QM DeliveryMay 2004 FM Delivery (Optimistic)September 2004

19. Realistic Schedule II