1. Power Electronics Dr. Imtiaz Hussain Assistant Professor email: imtiaz.hussain@faculty.muet.edu.pkimtiaz.hussain@faculty.muet.edu.pk URL :http://imtiazhussainkalwar.weebly.com/ Lecture-8 TRIAC & DIAC 1

2. TRIAC (Triode for Alternating Current) The major drawback of an SCR is that it can conduct current only in one direction. In AC systems it is often desirable to control both +ve and –ve half cycles. For this purpose a TRIAC is used. 2

3. TRIAC (Triode for Alternating Current) Triac is a three terminal five layer semiconductor switching device that can control flow of current of an ac load. Three terminals are designated as Main terminal 1 (MT1), Main Terminal 2 (MT2) and Gate (G). 3

4. TRIAC Packages 4

5. TRIAC (Triode for Alternating Current) Following point may be noted about the triac. 1.The triac can conduct current (with proper gate current) regardless of the polarity of the main terminals. 2.A triac can be turned on either with a positive or negative voltage at the gate terminal. 3.Like the SCR once the triac is fired into conduction, the gate lose all control. The triac can be turned off by reducing the circuit current to the value of holding current. 4.The main disadvantage of triacs of SCRs is that triacs have considerably lower current handling capabilities. Most triac are available in ratings of less than 40A at voltages up to 600V. 5

6. Triac Operation 6

7. Triac Characteristics 7 V-I characteristics of triac in the 1 st and 3 rd quadrants are essentially identical to those of an SCR in 1 st quadrant. Triac can be operated with either positive of negative gate control voltage. But in normal operation usually the gate voltage is positive in 1 st quaint and –ve in 3 rd quadrant.

8. Triac Phase Control Circuit 8

9. Triac Applications 9 High Power Lamp Switch Change over of Transformer Taps

10. Example-1 10

11. Example-1 Solution a)How will you trigger the triac by only +ve voltage? 11

12. Example-1 Solution b)How will you trigger the triac by only -ve voltage? 12

13. Triac Gate Control Circuits RC triggering Circuit 13

14. Triac Gate Control Circuits Double RC triggering Circuit 14

15. Triac Gate Control Circuits Break over device in triggering Circuit 15

16. Triac Gate Control Circuits UJT triggering Circuit 16

17. Triac Gate Control Circuits UJT triggering Circuit 17

18. DIAC (Diode for Alternating Current) A Diac is a two terminal three layer bidirectional device which can be switched from its OFF state to ON state for either polarity of applied voltage. 18

19. DIAC Packages 19

20. DIAC Characteristics 20

21. DIAC Applications Diacs are used primarily for triggering of triacs. Some of the circuit applications of diac are – Lamp Dimmer – Heat Control 21

22. DIAC Applications – Lamp Dimmer 22

23. DIAC Applications – Heat Control 23

24. Example-2 24

25. Example-2 Solution 25

26. END OF LECTURE-8 To download this lecture visit http://imtiazhussainkalwar.weebly.com/ 26