1. Renewable Energy Applications Jenna Beatty Jenny Lund Calvin Robertie

2. World Energy Use by Fuel

3. Goals of this Project BPM –Final document for Stantec –Checklist and Comparison Chart Renewable energy options –Most commonly used options Option Analysis –Location and Efficiency –Cost and Feasibility –Downsides and Environmental Impacts

4. Stantec’s Challenge Limited number of renewable energy “experts” Lack of standardized document or “textbook” Ample supply of information available Stantec would benefit from a BPM for entry level engineers

5. Decision Tree What are your energy needs? Electricity Generation Identify Available Options SolarWindGeothermalBiomassHydropower Heating/Cooling Identify Available Options GeothermalBiomass

6. Renewable Energy Options

7. Research Searched through sources to find: –Best Location –Cost Range –Efficiency –Downsides/Environmental Impacts –Case Studies

8. Chart CSP Solar PowerOffshore Wind Power Technology - Parabolic Trough - Linear Fresnel Reflector - CSP Dish - CSP Tower - Wind turbines are sited off the coast in waters up to 30m deep. Location - In the sunbelts of the world, and general between the latitudes of 40°North and 40° South. The American Southwest has a very large potential for CSP - The U.S. North east and Pacific Northwest from Oregon to Alaska are suitable. Cost - Power cost around $0.12 per kWh of power - Capital cost of plants vary between $2M and $5M per MW of capacity -Power costs $0.09 per kWh. - Capital cost range between $2M and $3M per MW of capacity Efficiency - Varies between technologies but is generally between 20- 40%. Energy storage systems can increase the efficiency. - Capacity factors range between 25-40% however offshore wind is generally high due to stronger, more consistent, and less turbulent winds offshore. Downsides - Large CSP plants take up large areas of land, however are often located in deserts. - Concentrated beams of sunlight can kill birds and insects - Visual aesthetics of shorelines are of concern - 0.001% of bird deaths are accounted from wind turbines - Marine ecosystems can be harmed, but initial research shows it to be very low. General Info. - Many downsides can be mitigated and the used of deserts and increase the value of previously degraded and unusable land. - 78% of U.S. electricity demand comes from the 28 states with shorelines.

9. Chart CSP Solar PowerOffshore Wind Power Cost - Power cost around $0.12 per kWh of power - Capital cost of plants vary between $2M and $5M per MW of capacity -Power costs $0.09 per kWh of power. - Capital cost range between $2M and $3M per MW of capacity

10. Checklist Concentrated Solar Power ___CSP power plants need a large area’s of land, up to hundreds or thousands of acres. ___ Cost of CSP plants range from $2M to $5M per MW ___Cost of electricity from CSP plants is around $0.12/kWh but is expected to drop in the near future due to increased research, manufacturing, and development. ___The best locations for CSP plants are often deserts which are unusable otherwise ___Current CSP technologies can convert 20-40% of sunlight ___When thermal storage units are incorporated into a CSP plant it can increase its capacity factor and continue to produce energy in the dark ___CSP plants emit no greenhouse gases during operation Offshore Wind ___Current technology only allows offshore turbines in water up to 30 Meters deep ___Minimum wind speeds of 8 mph are required for a turbine to generate electricity ___The coast of the Northeastern U.S. and the Cost of the Pacific Northwest from Oregon to Alaska are good locations to site offshore wind farms ___Farms cost around $2.4M per MW of capacity and electricity costs $.095/kWh ___Wind turbine capacity factors are around 30% however strong and more consistent offshore winds could increase that number. ___Farms can be properly sited to avoid fishing grounds and shipping lanes ___There is often public concern for the marine environment and visual aesthetics

11. BPM “Textbook” format –Detailed description of information provided in checklist and chart –Information is cited –Various case studies for each of the technologies

12. Design Example

13. Conclusion Each option is applicable in specific locations Biodiesel and geothermal heat pumps can be applicable almost anywhere Hybrid systems

14. Questions