Presentation is loading. Please wait.

Presentation is loading. Please wait.

Real Life Fin Problem By Matthew Elverud and Roger Smith.

Similar presentations


Presentation on theme: "Real Life Fin Problem By Matthew Elverud and Roger Smith."— Presentation transcript:

1 Real Life Fin Problem By Matthew Elverud and Roger Smith

2 Supplies Base with resistance Cap 8 Fins (washers) Thermocouple Introduction

3 Setup of Problem (Math) Methods used: Lumped Capacitance Horizontal Cylindrical Tube (Chp 9) Problem – how much do fins help pipes cool and how can heat transfer be expedited? Objective – How close is experimental data to calculated data.

4 Solution Please see attached Matlab file for in- depth solution parameters.

5 Results(Measured)

6 Conclusions and Recommendations Fins assist with heat transfer From calculations, the fins helped cool the pipe 6.653 time faster than without fins (please see note) Note: Our ratio was off because of all the assumptions we had to make when doing the calculations. We couldn't find exact values for some of our properties (such as h of the air)so we were forced to approximate. Also when we did our experiment our fins weren't attached as well as they could have been and we failed to add in our contact resistance. Also the top of the tube was open which allowed heat and evaporated water to escape. The assumption was made that this was a 1-D problem when in fact it was a much more complex problem.

7 Appendix Heat and Mass Transfer 6 th Edition MatLab was used for calculations (see attached file)


Download ppt "Real Life Fin Problem By Matthew Elverud and Roger Smith."

Similar presentations


Ads by Google