1. NSIS Flow ID and packet classification issues Hong Cheng, Qijie Huang, Takako Sanda, Toyoki Ue IETF#63 August, 2005

2. 2 Motivation & Goal Motivation  “Generating packet classifier from MRI” may not be able to function properly - Off path case - Multiple address case (including aggregation, tunneling) - Address variation case Goal  Have separate Filter info element (Filter List) and Routing info element (MRI), in order to - Support off path signaling - Support “sharing” QoS resources among multiple flows - Optimize NSIS signaling Reduce signaling overhead ## Filter List: A list of “Filter Spec”

3. 3 Off Path Signaling In off-path case, packet classifier needs to be different from MRI.  Signaling route is different from data route  NI/NR may be different from sender/receiver of the data packets Filter List supports  Carrying packet classification information separately - MRI is for routing/managing signaling messages

4. 4 Sharing QoS resources among multiple flows QoS resource sometimes needs to be shared between multiple flows  When predictive path is installed (such as mobility case), “sharing” QoS resource is necessary at overlapped section between current path and predictive path  In aggregation or tunnel cases, QoS resources also need to be shared among different flows Filter List supports  “ADD” a new packet classification information (like Filter Spec) into the list  “Share” QoS resources

5. 5 Optimize NSIS Signaling In Multiple Address case (e.g. multiple ports are used for one session) and in address variation case (e.g. ports changing during session), sending signaling for multiple times is required  Signaling routes are the same -> sending multiple signaling will be overhead  To support signaling aggregation -> different bindings are needed (Session binding; or Flow binding), it is overhead Filter List supports  Carrying multiple address information (i.e. Packet Classifier)  For MRI, one of multiple address can be employed Terminal Server Port 1 Port 2 Session 1 Filter List :={filter1 (Port1), filter2 (Port2) } MRI := Flow ID 1 (Port1)

6. 6 Considerations NAT traversal  In NAT, Filter List as well as MRI has to be changed according to the policy rule  Where the Filter List should be placed? - GIMPS Layer? - “Common” NSLP Layer?