1. An Introduction to the Engine Lathe By Trevor Rutz

2. The Lathe

3. Headstock

4. Spindle Speed Levers

5. Quick Change Gearbox Used to select the rate of travel for turning, facing, and threading.

6. Lead Screw and Feed Rod < Lead Screw < Feed Rod

7. Thread Chasing Dial References the rotation of the lead screw. References the rotation of the lead screw.

8. Carriage < Saddle < Apron

9. Ways Hardened sliding surfaces. Do not damage the ways!

10. Bed Made of Cast Iron Made of Cast Iron Backbone of Lathe Backbone of Lathe

11. Tailstock Supports long workpieces when machining.

12. Rotating Center 60 degree rotating center point. 60 degree rotating center point.

13. Drill Chuck

14. Tailstock Handwheel Turn the tailstock handwheel to advance the ram.

15. Cross Slide < Used for facing.

16. Compound Rest Used for: Short steep tapers Accurate shoulder lengths

17. Tool Post

18. 3 Jaw Chuck All 3 jaws move together.

19. 4 Jaw Chuck All 4 Jaws move independently Very accurate

20. Chuck Wrench Never let me catch you doing this!

21. Operator Lets Keep it Safe